We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular blue battery pack, 201 by 53 by 31 mm, with two 18 AWG wire leads

DUSLAN

DUSLAN 9.6V LiFePO4 Battery Pack 6400 mAh with Leads

SKU CH-NZHR-3Y86Y

A 9.6 V LiFePO4 pack delivers 6400 mAh through pre-wired 18 AWG leads with on-board PCB protection

  • Battery TypeBattery Pack
  • 6 V working voltage powers compatible devices
  • 6400 mAh capacity delivers 62 Wh of energy
  • LiFePO4 chemistry provides over 1000 charge cycles
  • Built-in PCB limits current to 2 A for protection
  • UN 38.3 passed for transport safety

9.6V LiFePO4 Pack for Custom Power Projects

This 9.6 volt lithium iron phosphate battery pack delivers 6400 mAh capacity and 62 Wh energy through pre-wired 18 AWG leads. Six 26650 cells in a 2 x 3 arrangement provide a compact 7.9 by 2.1 by 1.2 inch form factor weighing 1.2 lbs. The integrated PCB limits charge and discharge current to 2 amp while protecting against over-charge above 11.7 volt, over-discharge and short circuits. UN 38.3 certification confirms transport safety for this new pack.

Suits Portable Devices Needing Stable 9.6V Supply

Builders powering robotics, test equipment or RC platforms that operate between 7.5 and 11.4 volt will appreciate the flat discharge curve and over 1000 cycle life at 0.2C rate. The hard-wired leads simplify permanent installation but prevent hot-swap use. Applications requiring more than 2 amp continuous current, higher voltage rails or user-replaceable cells should consider alternative configurations.

6400 mAh Handles Moderate Loads With Ample Headroom

At the rated 2 amp limit the pack supplies roughly three hours of runtime before reaching the 7.5 volt cut-off. The 62 Wh capacity supports intermittent higher bursts within PCB limits while the LiFePO4 chemistry maintains performance across a wide temperature range. Extended high-drain sessions exceeding the 2 amp protection threshold will trigger shutdown, so size the load accordingly.

Highlights

  • 6 V working voltage powers compatible devices
  • 6400 mAh capacity delivers 62 Wh of energy
  • LiFePO4 chemistry provides over 1000 charge cycles
  • Built-in PCB limits current to 2 A for protection
  • UN 38.3 passed for transport safety

Specifications

Battery TypeBattery Pack

Questions about this item

What voltage charger do I need for the 9.6V LiFePO4 pack?

Use a LiFePO4 charger that stops at the pack's peak voltage of 11.4V and respects the 2A charge limit set by the onboard PCB.

Will the 2A discharge limit run my 9.6V brushed motor without tripping?

The PCB caps continuous draw at 2A; if your motor pulls more under load the pack will shut off, so verify the motor's stall current first.

How can I confirm the pack is healthy after the first charge cycle?

Measure the terminal voltage — it should read near 11.4V at full charge and stay above the 7.5V cut-off during use.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.