DUSLAN
DUSLAN 12.8V LiFePO4 Battery Pack 6000 mAh with Leads
A 12.8 V LiFePO4 pack of sixteen 18650 cells delivering 6000 mAh with built-in 2 A protection PCB and 6-inch 18 AWG leads
- Battery TypeBattery Pack
- 8 V LiFePO4 chemistry delivers stable voltage for consistent device operation
- 6000 mAh capacity provides extended runtime between charges
- built-in PCB limits current to 2 A and guards against over-charge, over-discharge and short circuits
- 16-cell 18650 pack in 8 × 2 layout measures 150 × 70 × 38 mm and weighs 666 g
- rated for more than 1000 cycles at 80 % capacity retention per IEC standard
Purpose and fit
The DUSLAN 12.8V LiFePO4 battery pack delivers 6000 mAh at 12.8 volts through pre-wired 18 AWG leads. It suits portable equipment, backup systems or custom projects that need a lightweight 77 Wh lithium-phosphate source with integrated protection.
Thermals and power
LiFePO4 chemistry provides superior high-temperature and storage performance compared with other lithium types. The onboard PCB limits charge and discharge current to 2 amps and disconnects the pack above 15.6 V or below 8 V, preventing over-charge, over-discharge and short-circuit events without active cooling.
Build and connections
Sixteen 18650 cylindrical cells in an 8 x 2 arrangement are housed in a 150 mm x 70 mm x 38 mm enclosure weighing 666 grams. Six-inch open-end wires allow direct soldering or connector fitting, while UN 38.3 certification confirms the pack meets transport safety requirements for lithium batteries.
Highlights
- 8 V LiFePO4 chemistry delivers stable voltage for consistent device operation
- 6000 mAh capacity provides extended runtime between charges
- built-in PCB limits current to 2 A and guards against over-charge, over-discharge and short circuits
- 16-cell 18650 pack in 8 × 2 layout measures 150 × 70 × 38 mm and weighs 666 g
- rated for more than 1000 cycles at 80 % capacity retention per IEC standard
Specifications
| Battery Type | Battery Pack |
|---|
Questions about this item
How do I connect the 6" 18 AWG open-end leads to my device, and what mistake should I avoid?
Solder or crimp the pre-wired leads to your load or connector; never exceed the PCB-limited 2 A discharge or the pack will shut down.
What replacement or maintenance will the 16-cell 18650 pack need after extended use?
After roughly 1000 cycles at 0.2 C the capacity drops to about 80 % of the original 6000 mAh, at which point the whole pack is typically replaced.
What limit appears first when I run the pack continuously at its maximum 2 A output?
The onboard PCB enforces a hard 2 A discharge ceiling, so sustained loads above that trigger immediate protection shutdown.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



