Drill America
Drill America DWC5-530-354 1-7/16" x 3" HSS Annular Cutter pneumatic accessory
Cuts 1-7/16" holes in metal using a magnetic drill press with a 3/4" Weldon shank and high-speed steel for wear resistance
- High-speed steel construction delivers hardness and toughness for wear resistance
- Cuts only necessary material producing a quality hole efficiently
- 3/4" Weldon shank fits magnetic drill presses for secure mounting
- Pilot pin included for accurate hole alignment and easy slug ejection
- Designed for fast, efficient hole making in general purpose applications
1-7/16" HSS Annular Cutter for Magnetic Drill
The Drill America DWC5-530-354 is a high-speed steel annular cutter built for magnetic drill presses with a 3/4" Weldon shank. It cuts only the material needed to form the hole, reducing waste and cutting time. This tool suits metal fabrication shops and maintenance crews who need fast, accurate holes in structural steel. It is not intended for hand drills or conventional drill presses.
Replaces twist drills
Switching to this annular cutter is worthwhile when you need clean, burr-free holes in thick plate without the torque reaction of a solid drill. The cutter removes a narrow ring of material, so the machine works less hard and the hole finishes closer to size. It will not help if your workflow requires drilling in non-magnetic materials or on job sites without a mag drill.
Weldon shank installs directly into compatible mag
Insert the 3/4" shank into the magnetic drill press arbor and secure the retaining pin; no adapters are required. The included pilot pin centres the cut and ejects the slug automatically. Problems usually arise when the cutter is run in a standard chuck or at incorrect speeds, which can snap the shank or burn the teeth. Always verify the press accepts a 3/4" Weldon shank before starting.
Highlights
- High-speed steel construction delivers hardness and toughness for wear resistance
- Cuts only necessary material producing a quality hole efficiently
- 3/4" Weldon shank fits magnetic drill presses for secure mounting
- Pilot pin included for accurate hole alignment and easy slug ejection
- Designed for fast, efficient hole making in general purpose applications
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
What shank size does the 1-7/16" annular cutter need to fit a magnetic drill press?
The cutter uses a 3/4" Weldon shank that locks directly into a magnetic drill press arbor.
Which pilot pin should be used when installing the 3" depth-of-cut cutter?
The included pilot pin must be inserted through the cutter centre to align the hole and eject the slug.
When should the high-speed steel cutter be replaced during regular use?
Replace it when the cutting edges dull, chip, or the tool no longer produces a clean hole.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
