Drill America
Drill America ANC5-530-354 1-7/16" X 3" nACo Coated Blue pneumatic accessory
Nano-composite coating extends annular cutter life by 30 percent for fast, clean holes in steel and cast iron using magnetic drill presses
- nACo Nano-Composite coating extends tool life up to 30%
- Cuts steel, cast iron, heated and stainless steels efficiently
- nACo Nano Coating protects against wear and high heat
- M2 High Speed Steel removes only necessary material for quality holes
- 3/4" Weldon Shank fits most magnetic drill presses
Magnetic Drill Press Accessory
This nACo coated annular cutter is built for magnetic drill presses only. The 3/4 inch Weldon shank fits most mag drills and the pilot pin is included. It is not compatible with standard hand drills or conventional drill presses.
High Speed Steel Upgrade
The nano composite blue coating extends tool life up to 30 percent over traditional HSS cutters. The upgrade is worth it when cutting difficult materials such as steel, cast iron, heated steel or stainless steel where heat and wear reduce uncoated cutter performance quickly.
Weldon Shank Limitation
The 3/4 inch Weldon shank restricts use to magnetic drill presses that accept this fitting. The cutter removes only the necessary material for fast hole making but cannot be used in standard chucks or collets. California Proposition 65 warnings apply for cancer and reproductive harm.
Highlights
- nACo Nano-Composite coating extends tool life up to 30%
- Cuts steel, cast iron, heated and stainless steels efficiently
- nACo Nano Coating protects against wear and high heat
- M2 High Speed Steel removes only necessary material for quality holes
- 3/4" Weldon Shank fits most magnetic drill presses
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
What shank size does the 1-7/16" annular cutter need to fit my magnetic drill press?
The cutter has a 3/4" Weldon shank that fits most magnetic drill presses. It is not compatible with standard hand drills or drill presses.
Which step is most often missed when installing the pilot pin in this cutter?
Insert the supplied pilot pin through the centre hole before mounting the cutter so it ejects the slug and centres the cut.
When should the nACo coated cutter be replaced instead of resharpened?
Replace it when the blue nano-composite coating has worn through to the M2 high-speed steel, as the coating provides the heat and wear protection.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
