Drill America
Drill America ANC5-530-163 1-5/8" X 1" nACo Coated Blue pneumatic accessory
nACo coated annular cutter cuts steel and stainless steel, extends tool life by 30 percent, and fits magnetic drill presses with Weldon shank
- nACo coating extends cutter life by 30%
- Nano-Composite layer resists wear and high heat
- M2 high-speed steel cuts only needed material
- 3/4" Weldon shank fits magnetic drill presses
- Includes pilot pin for accurate hole starting
Drill America ANC5-530-163 annular cutter
The Drill America ANC5-530-163 is an nACo Nano-Composite coated blue annular cutter designed for magnetic drill presses. It targets fabricators and maintenance technicians who need fast, efficient hole making in steel, cast iron, heated steel and stainless steel. The 3/4 inch Weldon shank fits most magnetic drill presses, also called mag drills. This tool is not for operators who need a cutter compatible with standard hand drills or conventional drill presses.
nACo coating and pilot pin
The nACo Nano-Composite coating increases tool life up to 30 percent compared to traditional high-speed steel annular cutters. It provides extra protection against tool wear and high heat when cutting difficult materials. The M2 high speed steel construction cuts only the necessary material for quality hole making. A pilot pin is included in the package to ensure proper alignment and slug ejection during operation.
Magnetic press installation only
Installation requires a magnetic drill press with a 3/4 inch Weldon shank receiver; the cutter must not be used with a standard hand drill or drill press. The pilot pin inserts through the cutter centre to align the cut and eject the slug. Common issues arise when the tool is forced into an incompatible chuck or when the pilot pin is omitted, causing misalignment and premature wear. California Proposition 65 warnings apply for cancer and reproductive harm.
Highlights
- nACo coating extends cutter life by 30%
- Nano-Composite layer resists wear and high heat
- M2 high-speed steel cuts only needed material
- 3/4" Weldon shank fits magnetic drill presses
- Includes pilot pin for accurate hole starting
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
How often will the nACo Nano-Composite coating need replacement under normal wear?
The nACo Nano-Composite Blue coating extends tool life up to 30% over traditional HSS annular cutters, so replacement intervals depend on material hardness and feed rates rather than a fixed schedule.
What limit appears first when cutting stainless steel continuously with this 1-5/8" cutter?
Heat buildup at the cutting edges becomes the limiting factor during sustained cuts in stainless or heated steels, even with the nACo coating's extra protection against high-temperature wear.
How much heat and vibration should I expect when running this cutter all day in a magnetic drill press?
The M2 high-speed steel body and nACo coating are designed to cut only necessary material, reducing friction and heat; the 3/4" Weldon shank provides a rigid fit in mag drills, minimising vibration during extended operation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
