Drill America
Drill America ANC5-530-111 1/2" X 1" nACo Blue Annular pneumatic accessory
A 1/2" x 1" nACo coated annular cutter that boosts tool life by 30% for fast hole making in steel, cast iron and stainless steel using magnetic drill presses
- nACo Nano-Composite coating extends tool life by 30% over standard HSS cutters
- Cuts steel, cast iron, heated and stainless steels with reduced wear and heat buildup
- M2 High Speed Steel removes only essential material for fast, efficient hole making
- 3/4" Weldon shank fits most magnetic drill presses for secure mounting
- Includes pilot pin for accurate hole alignment from the start
1/2" X 1" nACo Blue Annular Cutter
The Drill America ANC5-530-111 is a nano-composite coated annular cutter designed for magnetic drill presses. It targets metalworkers and fabricators who need efficient hole-making in tough alloys. The blue nACo coating extends tool life significantly compared to standard high-speed steel cutters. This accessory is built specifically for mag drill applications.
Upgrade from standard HSS annular cutters
The nACo nano-composite coating increases tool life up to 30 percent over traditional HSS annular cutters. It cuts difficult materials including steel, cast iron, heated and stainless steels with reduced wear. The jump is worth it when heat and abrasion quickly dull uncoated cutters. M2 high-speed steel construction removes only necessary material for fast, quality holes.
3/4" Weldon Shank fits magnetic drill presses
Installation is straightforward: the 3/4 inch Weldon shank seats directly into most magnetic drill presses. A pilot pin is included to align the cut and eject the slug. The cutter is for use with magnetic drill presses only; do not use with a standard hand drill or drill press. Misapplication in a conventional chuck causes damage and unsafe operation.
Highlights
- nACo Nano-Composite coating extends tool life by 30% over standard HSS cutters
- Cuts steel, cast iron, heated and stainless steels with reduced wear and heat buildup
- M2 High Speed Steel removes only essential material for fast, efficient hole making
- 3/4" Weldon shank fits most magnetic drill presses for secure mounting
- Includes pilot pin for accurate hole alignment from the start
Specifications
| Brand | DRILL AMERICA |
|---|
Questions about this item
What shank size does the ANC5-530-111 cutter use to fit a magnetic drill press?
The cutter has a 3/4" Weldon shank that fits most magnetic drill presses.
How is the pilot pin used when installing the cutter in the mag drill?
Insert the supplied pilot pin through the cutter's centre hole before securing the shank; the pin aligns the cut and ejects the slug.
When should the nACo coated annular cutter be replaced?
Replace the cutter when the nACo blue coating wears through or the cutting edges no longer produce clean holes in steel or stainless.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
