We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
DeVilbiss HVLP gravity spray gun kit with three tips and two cups

DeVilbiss

DeVilbiss 802342 HVLP Gravity Spray Kit 1.3 1.0 1.8 tips 600 250 cc cups

SKU CH-D8BK-X1N26

HVLP gravity spray kit with 1.3, 1.0 and 1.8 mm tips, 600 cc and 250 cc cups, operating at 30 PSI inlet for 10 PSI cap pressure

  • HVLP technology reduces overspray with 10 PSI air cap pressure
  • Three fluid tips 1.0 1.3 1.8 match coatings from detail to finish
  • Two gravity cups 600 cc and 250 cc suit large panels and spot repairs
  • 30 PSI inlet pressure runs finish gun at 13 CFM and detail gun at 8 CFM
  • Kit includes finish gun detail gun cups brush wrench and air adjusting valve with gauge

DeVilbiss 802342 HVLP Spray Kit

The DeVilbiss 802342 StartingLine kit provides a finish coat spray gun and a detail spray paint gun for automotive refinishing and detail spraying. It includes 1.3, 1.0 and 1.8 fluid tips plus 600 cc and 250 cc gravity cups. A cleaning brush, wrench and air adjusting valve with gauge complete the package.

Suited for automotive paint and detail work

This kit suits painters who need both a finish gun and a detail gun with interchangeable tip sizes for varied coatings. It is not for buyers who require a single gun only or those who need higher air volume than 13 CFM at the cap. Shops without a regulated 30 PSI inlet supply should look elsewhere.

Two cup capacities and three tip sizes

The 600 cc cup handles larger panels without frequent refills while the 250 cc cup suits detail areas and smaller jobs. At 30 PSI inlet the finish gun delivers 10 PSI cap pressure at 13 CFM and the detail gun at 8 CFM. Air demand beyond these figures will exceed the guns' rated performance.

Highlights

  • HVLP technology reduces overspray with 10 PSI air cap pressure
  • Three fluid tips 1.0 1.3 1.8 match coatings from detail to finish
  • Two gravity cups 600 cc and 250 cc suit large panels and spot repairs
  • 30 PSI inlet pressure runs finish gun at 13 CFM and detail gun at 8 CFM
  • Kit includes finish gun detail gun cups brush wrench and air adjusting valve with gauge

Specifications

No published specifications for this item yet.

Questions about this item

What compressor outlet size do I need to connect the 1/4" NPS air inlet?

A compressor with a 1/4" NPS outlet matches the gun inlet directly; otherwise use an adapter to 1/4" NPS.

Can I run the finish gun at 13 CFM and the detail gun at 8 CFM from the same compressor?

Yes, both guns operate at 30 PSI inlet and 10 PSI cap pressure; the compressor must supply at least 13 CFM for the finish gun and 8 CFM for the detail gun.

How do I verify the 10 PSI air cap pressure after setup?

Read the air adjusting valve gauge; it should show 10 PSI at the cap when the inlet is set to 30 PSI.

More in Electronics

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.