DELL
DELL Studio 1535 1536 1537 15.4" LCD Back Cover Sun Burst P608X
Replacement 15.4" LCD back cover with hinges, antenna cables and buttons for Dell Studio 1535, 1536 and 1537 in Sun Burst finish
- Complete lid assembly with hinges and cables for easy repair
- Sun Burst colour by Mike Ming restores original laptop appearance
- Compatible with Studio 1535 1536 1537 models for exact fit
- Includes power button WiFi catcher button and antenna cables
- Genuine Dell P608X part ensures reliable replacement quality
Replacement Lid for Studio 1535 1536 1537
This 15.4" LCD back cover assembly fits Dell Studio 1535, 1536 and 1537 laptops. It arrives new with left and right hinges, wireless antenna cables, power button with cable and the WiFi catcher button and circuit board pre-installed. The Sun Burst finish by Mike Ming matches the original chassis colour. It restores the structural top lid without requiring a full display panel swap.
Thermals noise and power draw
As a passive plastic cover with integrated hinges and cable routing it generates no heat, draws no power and produces no audible noise. The part simply replaces the damaged or worn lid and returns the laptop to its original mechanical state. No active cooling or electrical consumption is involved in its operation.
Sustained load behaviour
Under continuous daily opening and closing the hinges maintain alignment and the routed antenna and button cables resist fatigue. The assembly is designed to endure the same lifecycle as the factory lid without developing play or signal loss. It remains mechanically stable for the practical service life of the compatible Studio models.
Highlights
- Complete lid assembly with hinges and cables for easy repair
- Sun Burst colour by Mike Ming restores original laptop appearance
- Compatible with Studio 1535 1536 1537 models for exact fit
- Includes power button WiFi catcher button and antenna cables
- Genuine Dell P608X part ensures reliable replacement quality
Specifications
| Brand | Dell |
|---|
Questions about this item
How do I install the P608X back cover on my Studio 1535, and which step do people get wrong?
Remove the bezel, disconnect the antenna cables and power-button ribbon, swap the hinge brackets, then reconnect everything; the step most people miss is re-seating both wireless antenna cables into the new lid clips.
What maintenance will the P608X assembly need later?
The hinges are pre-greased and sealed; no lubrication is required. If the lid becomes loose, the hinge screws can be tightened, but the hinges themselves are not serviceable.
What limit appears first on the P608X under sustained daily opening and closing?
The plastic hinge mounts are the first wear point; after many cycles they can develop stress cracks, causing lid wobble before the hinges themselves bind.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



