We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small rectangular DLP chip on a green circuit board with silver connectors

DELL

DELL DMD DLP Chip for Hitachi WX9210 WX9211 WX9211-SD903W LP-WX3500

SKU CH-AZ7C-5CMZ6

Genuine DMD chip tested three times for clear projection with no dead pixels

  • TypeOthers
  • Genuine Dell OEM part ensures exact fit for Hitachi projectors
  • Extensively tested at least three times for zero dead pixels
  • Restores sharp, clear projection on WX9210 and WX9211 models
  • Compatible with LP-WX3500 and WX9211-SD903W series
  • Brand-new component replaces failed DMD chip to revive image quality

Genuine DMD DLP Chip for Hitachi Projectors

This genuine OEM DMD DLP chip is a direct replacement component for Hitachi projectors including the WX9210, WX9211, WX9211-SD903W and LP-WX3500 models. It restores the imaging engine so the projector can produce a clear picture again. The part is supplied new and has been extensively tested at least three times to confirm zero dead pixels. Installers working on these specific Hitachi models will find the correct fitment.

Passive Component With No Active Cooling

The chip itself is a solid-state micro-mirror array that draws no measurable power and generates no audible noise during operation. It relies entirely on the projector's existing lamp and cooling subsystem for thermal management. Because it contains no moving parts or onboard electronics, it adds no additional heat load or acoustic signature to the system. Normal use simply requires the host projector to be functioning within its original specifications.

Compatibility Limited to Listed Hitachi Models

This DMD chip is engineered exclusively for the WX9210, WX9211, WX9211-SD903W and LP-WX3500 projectors and will not fit or function in any other device. Buyers needing a replacement for a different projector series or a different manufacturer must source the correct part number for that hardware. The component is not programmable or adaptable to alternative light engines. Verify the exact model label on the projector before ordering.

Highlights

  • Genuine Dell OEM part ensures exact fit for Hitachi projectors
  • Extensively tested at least three times for zero dead pixels
  • Restores sharp, clear projection on WX9210 and WX9211 models
  • Compatible with LP-WX3500 and WX9211-SD903W series
  • Brand-new component replaces failed DMD chip to revive image quality

Specifications

TypeOthers

Questions about this item

How do I install the DMD chip in my Hitachi WX9210 projector without damaging the ribbon cable?

Power off and unplug the projector, remove the lamp module, then detach the optical-engine cover. Gently lift the ZIF connector latch, insert the DMD flex cable straight in, and lock the latch before reassembling.

What maintenance will the DLP chip in the LP-WX3500 require over time?

The sealed DMD array itself needs no user service. Keep the projector’s air filters clean and replace the lamp at the rated interval to prevent excess heat from degrading the micromirrors.

At what point does sustained brightness drop noticeably on the WX9211-SD903W with this chip installed?

Brightness loss appears first when the lamp reaches its rated 3500-hour life; the DMD chip maintains contrast until the light source dims below usable levels.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.