We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gold metalized Mylar tape rolls in a case of 96

Decker Tape Products, Inc.

Decker Tape Products, Inc. Gold Metalized Mylar Tape 3/8" x 72 Yd Case of 96 Rolls

SKU CH-DYW9-0YDGE

Gold metalised Mylar tape with acrylic adhesive, 18 lbs/in tensile strength and 30 oz/in adhesion, supplied as 96 rolls of 72 yards each

  • Gold finish aids electronic splice detection
  • Acrylic adhesive bonds reliably across 0°–300°F
  • 18 lbs/in tensile strength resists tearing
  • 30 oz/in adhesion holds on varied surfaces
  • 96 rolls × 72 yd supports high-volume use

Gold Metalized Mylar Tape

This gold metalized Mylar tape uses an acrylic adhesive and comes in a case of 96 rolls. Each roll measures 3/8 inch wide by 72 yards long. It suits electronic detection of roll splices or end-of-roll markers as well as decorative trim for albums, toys, appliances and boats. The film also handles splicing in high-temperature environments including infrared exposure.

Sustained High-Temperature Performance

The tape withstands continuous temperatures from 0 to 300 degrees Fahrenheit without losing integrity. Its 2 mil thickness and 18 lbs/in tensile strength resist mechanical stress during extended use. Acrylic adhesive maintains 30 oz/in adhesion across the full temperature range. Elongation of 60 percent allows the tape to conform to irregular surfaces while under load.

Practical Limits of Metalized Film

The 1 mil metalized layer provides reflectivity for optical sensing but does not conduct electricity for circuit paths. Adhesion values are measured on standard test panels; low-surface-energy plastics may reduce bond strength. Temperature rating applies to the film and adhesive together; substrate expansion at the upper limit can affect long-term holding power. The tape is not designed for structural load-bearing beyond the stated tensile figure.

Highlights

  • Gold finish aids electronic splice detection
  • Acrylic adhesive bonds reliably across 0°–300°F
  • 18 lbs/in tensile strength resists tearing
  • 30 oz/in adhesion holds on varied surfaces
  • 96 rolls × 72 yd supports high-volume use

Specifications

BrandThe Tape Supplies Shop

Questions about this item

Does the 300°F temperature rating mean the tape generates heat during continuous use?

No, the 300°F figure is the maximum environmental temperature the tape can withstand without degrading; the tape itself produces no heat.

What surface preparation or tools are needed for the acrylic adhesive to bond properly?

The acrylic adhesive bonds to clean, dry surfaces at room temperature; no primers, solvents or heat tools are required.

Will the 2 mil thickness and 18 lbs/in tensile strength let it splice older Mylar webs without tearing?

Yes, the 2 mil film with 18 lbs/in tensile strength and 60% elongation is designed for high-temperature splicing of existing Mylar webs.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.