We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Case of 24 gold metalized Mylar tape rolls, 2 inch by 72 yard

Decker Tape Products, Inc.

Decker Tape Products, Inc. Gold Metalized Mylar Tape 2" x 72 Yd Case of 24 Rolls

SKU CH-H6FY-35D3T

Gold metalized Mylar tape with acrylic adhesive, 18 lbs/in tensile strength, 30 oz/in adhesion and 60% elongation withstands 0-300°F for splicing and detection

  • Gold film reflects light for electronic splice detection
  • Acrylic adhesive bonds at 30 oz/in across 0°–300°F range
  • 18 lbs/in tensile strength resists tearing during high-speed processing
  • 2 mil thickness with 60% elongation conforms to irregular surfaces
  • Case of 24 rolls supplies 72 yards each for continuous production

Gold Metalized Mylar Tape — Industrial Splicing &

This 2-inch by 72-yard gold metalized Mylar tape uses an acrylic adhesive for electronic splice detection and high-temperature splicing tasks. It serves maintenance teams, packaging lines and hobbyists who need a reflective film that identifies roll ends or adds decorative trim. Supplied as a case of 24 rolls for volume use.

Replaces standard masking

Upgrade when a job demands 300 °F resistance, 18 lbs/in tensile strength and 30 oz/in adhesion that conventional tapes cannot hold. The 2 mil film with 60 % elongation conforms to irregular surfaces without splitting. Not for buyers who need a wider web, a different adhesive chemistry or a non-reflective backing.

Holds adhesion and tensile load through sustained

Acrylic adhesive maintains bond from 0 °F to 300 °F during continuous infrared exposure or oven passes. The metalized film reflects radiant heat while the 2 mil carrier resists creep under 18 lbs/in tension. Elongation stays consistent across cycles so splices remain detectable by electronic sensors.

Highlights

  • Gold film reflects light for electronic splice detection
  • Acrylic adhesive bonds at 30 oz/in across 0°–300°F range
  • 18 lbs/in tensile strength resists tearing during high-speed processing
  • 2 mil thickness with 60% elongation conforms to irregular surfaces
  • Case of 24 rolls supplies 72 yards each for continuous production

Specifications

BrandThe Tape Supplies Shop

Questions about this item

What width roll and total yardage does each case contain?

Each case holds 24 rolls that are 2 inches wide and 72 yards long per roll.

How is the acrylic adhesive applied and what surface preparation avoids lifting?

The acrylic adhesive is pre-applied to the 2 mil film; clean the surface to remove oils or dust before pressing the tape firmly for full contact.

When should a roll be replaced based on the tape's temperature limits?

Replace the roll if it will be exposed beyond the 0 to 300 degrees Fahrenheit range, since performance outside that window is not guaranteed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.