DBTLAP
DBTLAP Laptop CPU Fan for Toshiba Qosmio F50 F55 F55-Q502 AB7505HX-SB3 BSB0705HC -9C2T
Replacement CPU cooler for Toshiba Qosmio F50 and F55 series laptops, tested before shipping
- Accessory TypeCooler
- Direct replacement for Qosmio F50 F55 models
- Tested individually to ensure 100% operation
- Includes single fan unit ready to install
- Verify part numbers AB7505HX-SB3 BSB0705HC -9C2T match original
- Produced by Forcecon ADDA Sunon or Kipo
Direct Replacement Fan for Qosmio F50 and F55
This CPU cooling fan is built for Toshiba Qosmio F50, F55 and F55-Q502 models. It suits owners whose original fan has become noisy or stopped spinning. The part matches the AB7505HX-SB3 and BSB0705HC references used in those chassis.
Upgrade When the Original Fails or Runs Loud
Swap this unit in when the factory fan no longer moves enough air or develops bearing rattle. The jump is worth it if thermals throttle the processor or the laptop shuts down under load. Each fan is tested before dispatch to confirm it spins correctly.
Straightforward Swap With Careful Alignment
Installation follows the standard laptop teardown: remove the bottom cover, disconnect the old cable and fit the new assembly. What usually goes wrong is ordering the wrong variant, so compare the part number and connector with the original before purchasing.
Highlights
- Direct replacement for Qosmio F50 F55 models
- Tested individually to ensure 100% operation
- Includes single fan unit ready to install
- Verify part numbers AB7505HX-SB3 BSB0705HC -9C2T match original
- Produced by Forcecon ADDA Sunon or Kipo
Specifications
| Accessory Type | Cooler |
|---|
Questions about this item
Will this fan fit the Toshiba Qosmio F50, F55 and F55-Q502 models?
The listing names those exact model numbers as compatible, so the fan is built to match the mounting points and connector on those machines.
Which step do installers most often miss when fitting this replacement fan?
Many people forget to clean the old thermal paste off the heatsink and apply fresh compound before securing the new fan.
What part will need attention again after extended use?
The fan bearing is the wear item; when it becomes noisy or spins slower, the whole unit should be replaced.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



