We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black laptop cooling fan with wire connector

DBTLAP

DBTLAP laptop cooling fan for WINMA EGC-84090V1-0AH 20302D6417P29341 5V 2.5W .5A

SKU CH-VP43-GK4HA

Replacement cooling fan compatible with WINMA EGC-84090V1-0AH, rated 5V 2.5W 0.5A

  • Accessory TypeCooler
  • Drop-in replacement for WINMA EGC-84090V1-0AH
  • 5 V, 2.5 W, 0.5 A power draw matches original spec
  • Pre-tested unit ships ready to install
  • Photo-verified fit avoids wrong-part orders
  • Model-number check service confirms 100 % compatibility

Replacement fan for WINMA EGC-84090V1-0AH

This DBTLAP cooling fan is a direct replacement part for the WINMA EGC-84090V1-0AH laptop. It is intended for owners of that specific model who need to replace a worn or failed internal cooler. Compatibility is tied to the 20302D6417P29341 part number, so verifying the original component against the supplied photos is essential before ordering.

5 V 2.5 W 0.5 A thermal profile

The fan operates at 5 V with a power draw of 2.5 W and a current rating of 0.5 A. These electrical figures define its thermal capacity and acoustic behaviour inside the original chassis. Each unit is tested before shipping to confirm correct spin-up and airflow performance at the specified voltage.

Upgrades a worn original cooler

This part replaces the factory-installed fan when bearing noise, reduced airflow or complete failure occurs. The jump is worth it when the laptop begins to throttle or shut down under load because the original cooler can no longer dissipate heat. Buyers who need a different form factor, a higher voltage model or a complete cooling-pad assembly will not find a match here.

Highlights

  • Drop-in replacement for WINMA EGC-84090V1-0AH
  • 5 V, 2.5 W, 0.5 A power draw matches original spec
  • Pre-tested unit ships ready to install
  • Photo-verified fit avoids wrong-part orders
  • Model-number check service confirms 100 % compatibility

Specifications

Accessory TypeCooler

Questions about this item

How do I install the 5V 2.5W fan in the WINMA EGC-84090V1-0AH and what step is often missed?

Match the part number 20302D6417P29341 to your original fan, disconnect power, swap the connector, then verify the .5A rating on the label before closing the case.

What maintenance will this replacement fan need over time?

Clean dust from the blades and vents every few months; the fan is a single moving part with no lubrication points, so replacement is only needed if noise or airflow drops.

What limit appears first when the fan runs continuously at 5V 2.5W?

The .5A current draw sets the thermal ceiling; sustained load will hit the motor’s temperature limit before the 5V supply reaches its capacity.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.