We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A black laptop cooling fan with four-pin connector visible

DBTLAP

DBTLAP laptop cooling fan 06T7HN NS75C31-19J08 4PIN

SKU CH-8MN2-BPN46

Replacement laptop cooling fan for models 06T7HN and NS75C31-19J08 with a 4-pin connector

  • Accessory TypeCooler
  • Direct replacement for 06T7HN NS75C31-19J08 models
  • 4-pin connector ensures secure motherboard fit
  • Pre-tested unit reduces installation risk
  • Single fan module matches original cooler design
  • Compatibility check service avoids wrong-part orders

Replacement fan for 06T7HN NS75C31-19J08 cooler

This new laptop cooling fan is a direct replacement part for the 06T7HN NS75C31-19J08 cooler assembly. It uses a four-pin connector for power and speed control. The unit is designed for owners of compatible laptops who need to restore original cooling performance. Each fan is tested before shipping to verify operation.

Upgrading from a worn or noisy original fan

This part replaces a failed, noisy or under-performing factory fan in the same cooler assembly. The jump is worth it when the original bearing has worn out, airflow has dropped or the speed signal no longer reports correctly. Matching the part number ensures the replacement fits the mounting points and connector without modification. Buyers who need a different connector layout or a higher airflow rating cannot use this unit.

Fits into the existing cooler housing

The fan slots into the current cooler housing and connects to the motherboard header using the four-pin plug. No extra brackets, cables or thermal pads are included in the package. Installing it frees up thermal headroom for the processor and graphics chip by restoring the designed airflow path. Builders who need a complete cooler assembly with heatsink or heatpipes must source those separately.

Highlights

  • Direct replacement for 06T7HN NS75C31-19J08 models
  • 4-pin connector ensures secure motherboard fit
  • Pre-tested unit reduces installation risk
  • Single fan module matches original cooler design
  • Compatibility check service avoids wrong-part orders

Specifications

Accessory TypeCooler

Questions about this item

Does this 4PIN fan match the 06T7HN NS75C31-19J08 cooler mounting holes?

The fan is built for the 06T7HN NS75C31-19J08 cooler; compare the screw-hole pattern in the photos with your original unit before ordering.

What is the tricky step when fitting the 4PIN connector onto the motherboard header?

Align the keyed 4PIN plug with the header notch, press straight down until the latch clicks, and avoid angling the connector or bending the pins.

How often should the 06T7HN NS75C31-19J08 fan be cleaned or replaced?

Clean dust from the blades every 6 months; replace the fan if bearing noise appears or airflow drops noticeably.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.