DBTLAP
DBTLAP GPU Fan for CLEVO NH50RA NH50EA EGC-77100V1-0AH 5V 2.5A
Replacement GPU cooling fan compatible with Clevo NH50RA and NH50EA laptops, tested before shipping
- Accessory TypeCooler
- Direct GPU cooling for CLEVO NH50RA NH50EA
- 5 V 2.5 A power rating for stable operation
- Pre-tested unit reduces installation risk
- Exact part match for EGC-77100V1-0AH
- Single fan replaces original cooler assembly
Replacement GPU Fan for Clevo NH50RA and NH50EA
This new cooling fan is designed as a direct replacement for the GPU cooler in Clevo NH50RA and NH50EA laptops. It operates at 5 volts with a 2.5 amp rating and includes a 0.5 amp fan motor. The part matches the EGC-77100V1-0AH specification and is sold as a single unit.
Upgrading from a worn or failed original cooler
The jump is worth it when the existing fan develops bearing noise, vibration or reduced airflow that leads to thermal throttling. Each unit is tested before shipping and the supplier advises verifying the part number and photos against the original component to ensure 100 percent compatibility before ordering.
Cooling capacity for the discrete GPU module
The fan provides targeted airflow for the graphics subsystem in the listed Clevo models. It handles the thermal load of the GPU under normal gaming and workload conditions. It does not address CPU cooling or system-wide airflow, and it cannot compensate for degraded thermal paste or blocked heatsink fins elsewhere in the chassis.
Highlights
- Direct GPU cooling for CLEVO NH50RA NH50EA
- 5 V 2.5 A power rating for stable operation
- Pre-tested unit reduces installation risk
- Exact part match for EGC-77100V1-0AH
- Single fan replaces original cooler assembly
Specifications
| Accessory Type | Cooler |
|---|
Questions about this item
Will this fan fit my CLEVO NH50RA laptop?
The fan is built for CLEVO NH50RA and NH50EA models with part number EGC-77100V1-0AH, so verify that code on your original cooler.
How do I install the replacement GPU fan?
Disconnect the battery, remove the old cooler, match the connector to the motherboard header, and secure the four mounting screws without over-tightening.
When should I replace this fan again?
Replace it if bearing noise returns, RPM drops below spec, or the blades show dust buildup that cleaning cannot clear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



