We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A single black laptop GPU cooling fan with plastic housing and wire connector

DBTLAP

DBTLAP GPU Cooling Fan HP Envy 17-CW0000 17T-CW000 17-CW1000CA 17-CW1023CL 17-CW0023DX 17-CW0097NR

SKU CH-9SAC-44N4T

GPU cooling fan replaces the graphics processor fan in compatible HP Envy 17 series laptops

  • Accessory TypeCooler
  • GPU cooling fan keeps HP Envy 17 series graphics temperatures lower
  • Tested before shipping so the replacement arrives ready to install
  • Direct fit for Envy 17-CW0000, 17T-CW000 and 17-CW1000CA models
  • Compatible with 17-CW1023CL, 17-CW0023DX and 17-CW0097NR variants
  • Single fan unit replaces the original GPU cooler without modification

Replacement GPU Cooling Fan for HP Envy 17

This DBTLAP cooling fan replaces the original GPU cooler in specific HP Envy 17 models including the 17-CW0000, 17T-CW000, 17-CW1000CA, 17-CW1023CL, 17-CW0023DX and 17-CW0097NR. It is intended for owners of these laptops experiencing overheating or fan failure. The part restores proper thermal management for the graphics processor. Each unit is tested by the supplier before shipping.

Upgrading from a worn or noisy original cooler

The jump is worth it when the existing fan spins loudly, rattles or stops spinning under load. Rising GPU temperatures and thermal throttling during gaming or rendering are clear indicators. This replacement addresses those symptoms directly without modifying the laptop's cooling architecture. Buyers needing a complete heatsink assembly or liquid cooling conversion will not find that scope here.

Straightforward swap for experienced technicians

Installation requires disassembling the laptop to access the GPU heatsink, disconnecting the old fan cable and securing the new unit. What usually goes wrong is ordering without verifying the exact part number against the original fan shown in the product photos. Connector orientation and mounting screw positions must match precisely. The supplier recommends sending your model number for confirmation if uncertain.

Highlights

  • GPU cooling fan keeps HP Envy 17 series graphics temperatures lower
  • Tested before shipping so the replacement arrives ready to install
  • Direct fit for Envy 17-CW0000, 17T-CW000 and 17-CW1000CA models
  • Compatible with 17-CW1023CL, 17-CW0023DX and 17-CW0097NR variants
  • Single fan unit replaces the original GPU cooler without modification

Specifications

Accessory TypeCooler

Questions about this item

Does the fan screw directly into the HP Envy 17-CW0000 heatsink?

The fan is built to match the original GPU cooler mounting points on the HP Envy 17-CW0000 series, so the existing screw holes line up.

Which step do people miss when swapping the GPU fan on the 17-CW1000CA?

Many forget to peel the old thermal pad off the heatsink and apply a fresh one before seating the new fan, causing poor contact.

How often should the replacement fan in the 17-CW0023DX be cleaned?

Blow dust from the intake vents every three to six months; replace the fan again only if bearing noise returns or airflow drops.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.