We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black 87mm cooling fan with four-pin connector

DBTLAP

DBTLAP 87mm Fan For MSI ARMOR RX570 RX580 40mm 4Pin PLD09210B12HH 0.4A

SKU CH-JNH1-1VYHY

87 mm replacement fan with 4-pin connector fits MSI Armor RX 570 and RX 580 dual-fan cards

  • Accessory TypeCooler
  • Keeps MSI ARMOR RX570 RX580 running cool with 87mm replacement fan
  • 4-pin PWM connector enables precise speed control for quieter operation
  • Direct-fit 40mm mounting matches original PLD09210B12HH specifications
  • 4A draw delivers efficient airflow without overloading graphics card power
  • Each unit tested before shipping to ensure reliable drop-in installation

Replacement Fan For MSI ARMOR Graphics Cards

This 87mm replacement cooler fits MSI ARMOR RX570 and RX580 dual-fan models using the PLD09210B12HH part number. It mounts directly onto the existing heatsink using the original screw pattern and connects through the standard 4Pin header. The unit draws .4A at 12V and ships as a single tested fan without additional brackets or cables. Buyers should verify the part number printed on their current fan before ordering.

Repair Shops And Owners Of Matching MSI ARMOR Cards

The part suits technicians and enthusiasts replacing a noisy or failed cooler on the exact GPU models listed above. It will not fit reference designs, single-fan variants, or cards from other manufacturers that share the RX570 or RX580 chipset but use different cooler layouts. Laptop users, builders needing a new GPU, or anyone without the PLD09210B12HH sticker on their original fan should look elsewhere.

4Pin Connector And PLD09210B12HH Part Number

The 4Pin connector and PLD09210B12HH marking are the only specifications that guarantee correct electrical and mechanical fit on the target MSI ARMOR cards. Voltage is 12V and current draw is .4A, matching the original fan controller limits. If the existing cooler uses a different pin count, part number, or mounting hole spacing, this unit will not install or report speed correctly.

Highlights

  • Keeps MSI ARMOR RX570 RX580 running cool with 87mm replacement fan
  • 4-pin PWM connector enables precise speed control for quieter operation
  • Direct-fit 40mm mounting matches original PLD09210B12HH specifications
  • 4A draw delivers efficient airflow without overloading graphics card power
  • Each unit tested before shipping to ensure reliable drop-in installation

Specifications

Accessory TypeCooler

Questions about this item

How do I install the 87mm 4-pin fan on my MSI ARMOR RX570 or RX580, and what step do people often get wrong?

Match the PLD09210B12HH part number and 4-pin connector to the original fan, then secure the 87mm frame; the common mistake is fitting a 40mm fan instead of the correct 87mm unit.

What maintenance or replacement will the 0.4A 12V fan need over time?

Dust buildup on the 87mm blades reduces airflow, so clean with compressed air every few months; if bearing noise appears, replace the entire PLD09210B12HH fan assembly.

What limit appears first when the fan runs continuously at full load?

The 0.4A current draw at 12V sets the thermal ceiling; sustained maximum RPM will hit the motor’s rated power limit before any other constraint.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.