We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small brass impeller with transparent centre, two-inch diameter

Dayton

Dayton PPTPXW805G Brass Impeller 2 in

SKU CH-RPGQ-DMXXJ

A brass vortex impeller measuring two inches in diameter fits Dayton straight centrifugal pump models 5PXW8, 5PXW9 and 5PXX4

  • ColorTransparent
  • Brass construction resists corrosion for longer service life
  • Vortex impeller design handles solids without clogging
  • Two-inch diameter fits Dayton straight centrifugal pumps
  • Compatible with Dayton models 5PXW8, 5PXW9, 5PXX4
  • Transparent housing allows visual inspection of flow

Brass Impeller for Straight Centrifugal Pumps

This Dayton PPTPXW805G brass impeller is a direct replacement component for specific pump models. It fits Dayton straight centrifugal pumps using manufacturer numbers 5PXW8, 5PXW9 and 5PXX4. Maintenance teams and facility managers use it to restore pump performance during scheduled service or emergency repair.

Vortex Design Handles Solids in Continuous Operation

The 2 in diameter vortex impeller moves liquids containing suspended solids without clogging. Brass construction resists corrosion from water-based fluids, reducing wear during extended run times. The design maintains steady flow rates while keeping vibration and motor load within normal limits for the host pump.

Brass Body Withstands Repeated Installation Cycles

The 805 model number identifies this specific impeller variant for accurate reordering. Its brass body tolerates the mechanical stress of repeated removal and reinstallation during impeller inspections. Transparent packaging lets technicians verify the part visually before breaking the seal. Buyers needing impellers for non-Dayton pumps or different diameter requirements cannot use this component.

Highlights

  • Brass construction resists corrosion for longer service life
  • Vortex impeller design handles solids without clogging
  • Two-inch diameter fits Dayton straight centrifugal pumps
  • Compatible with Dayton models 5PXW8, 5PXW9, 5PXX4
  • Transparent housing allows visual inspection of flow

Specifications

BrandDAYTON
ColorTransparent

Questions about this item

How is the 2 in brass vortex impeller installed on a Dayton straight centrifugal pump, and what step do people get wrong?

The impeller slides onto the motor shaft and is secured with the pump's original fastener; the step often missed is verifying the keyway alignment before tightening so the brass vanes do not bind against the volute.

What maintenance or replacement will the brass vortex impeller need later?

Inspect the brass vanes annually for erosion or mineral build-up; replace the impeller if the vortex passages show measurable wear that reduces flow or causes vibration.

What limit shows up first when the brass vortex impeller runs continuously on a Dayton straight centrifugal pump?

The brass material's erosion resistance is the first limit under sustained operation; abrasive particles in the liquid gradually thin the vane edges and reduce pumping efficiency.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.