We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Dayton rotary gear pump cast iron half-inch NPT ports one-third horsepower

Dayton

Dayton 6DHH9 Rotary Gear Pump 1/3 hp 1/2 in NPT 40 psi 115/230V

SKU CH-SCHM-472RW MPN 6DHH9

Rotary gear pump delivers up to 40 psi with a 1/3 hp motor on 115/230V AC

  • TypeDrain Components
  • Handles fluids up to 100 SUS viscosity with spur steel gears
  • Maximum 40 psi pressure suits moderate-demand transfer tasks
  • Operates from 40 to 375 °F for wide temperature range
  • Single-phase 115/230 V motor simplifies electrical hookup
  • Totally enclosed fan-cooled enclosure protects motor in harsh environments

Application fit

The Dayton 6DHH9 is a rotary gear pump rated for 40 psi maximum operating pressure and 1/3 hp motor output. It handles fluids up to 100 SUS viscosity through 1/2 in NPT inlet and discharge ports. The unit runs on single-phase 115/230V AC power with a totally enclosed fan-cooled motor enclosure.

Sustained operation

Operating temperature spans from 40 Degrees F to 375 Degrees F, allowing continuous duty across a wide thermal range. The spur gear design uses steel gears for consistent displacement under load. Motor protection comes from the totally enclosed fan-cooled housing, which dissipates heat during extended run cycles without external ventilation requirements.

Upgrade context

This pump replaces older units that lack the 375 Degrees F upper temperature limit or the dual-voltage 115/230V flexibility. The jump is worthwhile when the application demands both higher temperature tolerance and voltage adaptability in a single package. It does not suit systems requiring pressures above 40 psi or viscosities exceeding 100 SUS.

Highlights

  • Handles fluids up to 100 SUS viscosity with spur steel gears
  • Maximum 40 psi pressure suits moderate-demand transfer tasks
  • Operates from 40 to 375 °F for wide temperature range
  • Single-phase 115/230 V motor simplifies electrical hookup
  • Totally enclosed fan-cooled enclosure protects motor in harsh environments

Specifications

TypeDrain Components
BrandDayton
Model6DHH9

Questions about this item

How much heat does the 1/3 hp motor generate when the pump runs continuously at 40 psi?

The motor is totally enclosed fan cooled and rated for operation up to 375 °F, so sustained duty at 40 psi stays within its thermal design.

What piping and power supply must already be in place for this 1/2 in NPT pump?

You need 1/2 in NPT inlet and outlet piping plus a single-phase 115/230 V AC circuit matched to the motor nameplate.

Will the steel spur gears handle the same 100 SUS fluid that my older cast-iron pump moved?

Yes — the steel spur gears are rated for viscosity up to 100 SUS, matching the fluid spec of your existing system.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.