We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Dayton 1 HP capacitor-start motor, open drip-proof, 56Z frame, transparent finish

Dayton

Dayton 5BE58 1 HP 1725 RPM 115/208-230V 56Z ODP hvac control

SKU CH-YVTM-2V51H

Single-phase capacitor-start motor delivers 1 hp at 1725 RPM with 115/208-230 V operation and open drip-proof enclosure

  • ColorTransparent
  • 1 HP capacitor-start motor delivers 1725 RPM for fan and blower applications
  • Dual-voltage 115/208-230V AC wiring suits multiple supply configurations
  • 56Z frame with stud mounting fits standard HVAC equipment
  • Open drip-proof enclosure rated for 40 °C continuous duty
  • Auto thermal protection and 1.15 service factor extend operating life

HVAC Control Motor for Continuous Duty

The Dayton 5BE58 is a 1 hp single-phase capacitor-start motor built for HVAC control applications. It runs at a nameplate speed of 1725 rpm with a 56Z frame and open drip-proof enclosure. The unit operates on 115/208-230 V AC at 60 Hz and is rated for continuous duty cycles in ambient temperatures up to 40 degrees C.

Thermal Protection and Power Draw in Normal Use

Automatic thermal protection safeguards the motor during standard operation. Insulation class B supports the 1.15 service factor across the voltage range. Full-load current measures 12.8 A at 115 V and 6.4 A at 208-230 V. The motor is usable at 208 V but not at 200 V.

Sustained Load Behaviour

Under continuous load the motor maintains its 1725 rpm rating within the 1.15 service factor limit. Auto thermal protection reacts to prolonged heating rather than momentary spikes. CW/CCW shaft rotation and stud mounting provide installation flexibility for sustained airflow demands.

Highlights

  • 1 HP capacitor-start motor delivers 1725 RPM for fan and blower applications
  • Dual-voltage 115/208-230V AC wiring suits multiple supply configurations
  • 56Z frame with stud mounting fits standard HVAC equipment
  • Open drip-proof enclosure rated for 40 °C continuous duty
  • Auto thermal protection and 1.15 service factor extend operating life

Specifications

BrandDAYTON
ColorTransparent

Questions about this item

How do I wire the 56Z frame motor for 115 V versus 208-230 V and which terminal block connections are often reversed?

For 115 V connect the two 12.8 A windings in parallel using the low-voltage diagram on the nameplate; for 208-230 V wire them in series for 6.4 A. The step most installers reverse is swapping the two start-winding leads, which locks rotation to the wrong direction.

What maintenance does the capacitor-start motor need and when should the start capacitor be replaced?

The open drip-proof enclosure requires quarterly cleaning of dust from the ventilation openings and annual bearing relubrication. The start capacitor typically lasts five to seven years; replace it when the motor hums but fails to reach 1,725 RPM on startup.

At what ambient temperature does the auto thermal protection trip during continuous duty at 1.15 service factor?

The Class B insulation and auto-reset thermal protector are rated for a maximum ambient of 40 °C. Sustained operation above that temperature, especially at full 1 hp load, will cause the protector to cycle the motor off until it cools.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.