Dayton
Dayton 5BE54 PSC Motor 1/2 HP 1725 RPM 115/230V 48Z ODP
Single-phase PSC blower motor delivers 1/2 HP at 1725 RPM on 115/230 V AC
- 1/2 HP PSC motor delivers 1725 RPM for direct-drive blowers
- Dual 115/230 V operation fits common single-phase supplies
- Auto thermal protection guards windings during continuous duty
- Open dripproof 48Z frame mounts at any angle via ring/stud
- Insulation class B rated for 40 °C max ambient
Direct-drive blower motor
The Dayton 5BE54 is a single-phase permanent-split-capacitor motor rated at one-half horsepower and 1,725 RPM. It operates on 115/230 V AC at 60 Hz and draws 6.0 amps at the lower voltage or 3.0 amps at the higher voltage. The 48Z frame fits ring or stud mounting in any orientation.
Build integration
Open dripproof enclosure allows airflow while protecting windings from falling moisture in indoor HVAC equipment. Automatic thermal protection resets after a fault without manual intervention. Continuous duty rating and Class B insulation suit round-the-clock blower service in air handlers, furnaces or exhaust fans.
Capacity and headroom
Half-horsepower output handles typical residential and light-commercial direct-drive blower wheels within the 40 °C maximum ambient limit. Service factor of one leaves no overload margin, so the motor must not be driven beyond nameplate load. Operation at 200 V or 208 V is not supported.
Highlights
- 1/2 HP PSC motor delivers 1725 RPM for direct-drive blowers
- Dual 115/230 V operation fits common single-phase supplies
- Auto thermal protection guards windings during continuous duty
- Open dripproof 48Z frame mounts at any angle via ring/stud
- Insulation class B rated for 40 °C max ambient
Specifications
| Brand | DAYTON |
|---|
Questions about this item
What is the maximum ambient temperature this 1/2 HP motor can handle continuously?
The motor is rated for a maximum ambient temperature of 40 Degrees C during continuous duty operation.
How much current does the motor draw at full load on 115V and 230V circuits?
Full load current is 6.0 amps at 115V and 3.0 amps at 230V, with a 1.0 service factor.
What mounting hardware or frame does the buyer need to install this 48Z frame motor?
It uses a ring and stud mounting type and can be installed in any angle position.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
