Dayton
Dayton 33RH46 galvanised steel cable 1/8 in 50 ft 1x19 420 lb WLL
Galvanised steel cable, 1 x 19 strand, 50 ft length, 420 lb working load limit
- TypeTraffic & Parking Lot
- Galvanised steel resists corrosion for long outdoor life
- 1 x 19 strand construction gives high strength with minimal stretch
- 420 lb working load limit handles heavy tension safely
- 50 ft length provides ample reach for fencing or rigging
- 1/8 in diameter fits standard hardware and clamps
Cable Construction
This 50 ft galvanised steel cable uses a 1 x 19 strand configuration for a smooth, uncoated finish. The 1/8 in outside diameter provides a working load limit of 420 lb. It is sold new and intended for traffic and parking lot applications.
Suitable Uses
The cable suits installations requiring a single 50 ft length with a 420 lb working load limit. Buyers who need a different length, a higher working load limit or a coated finish should look at other options.
Capacity and Headroom
The 1 x 19 construction handles straight tension loads up to the 420 lb working load limit. It runs out when the application demands a longer continuous run, a greater working load or a protective coating.
Highlights
- Galvanised steel resists corrosion for long outdoor life
- 1 x 19 strand construction gives high strength with minimal stretch
- 420 lb working load limit handles heavy tension safely
- 50 ft length provides ample reach for fencing or rigging
- 1/8 in diameter fits standard hardware and clamps
Specifications
| Brand | DAYTON |
|---|---|
| Type | Traffic & Parking Lot |
Questions about this item
What fittings do I need to terminate the 1/8 in. galvanised steel cable?
The cable has no end fittings, so you must supply thimbles, wire-rope clips or swaged sleeves rated for 1/8 in. diameter and the 420 lb working load limit.
Can I mix this 1x19 strand cable with older 7x7 cable on the same run?
Mixing strand constructions changes stiffness and fatigue behaviour; use matching 1x19 cable throughout a single tensioned run for consistent performance.
How do I verify the 50 ft cable meets the 420 lb working load after installation?
Apply a calibrated proof load not exceeding 420 lb and confirm no permanent deformation or strand slippage at the terminations.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
