Dayton
Dayton 32UK01 Non-Illuminated Selector Switch Cam E 30mm
Non-illuminated 30 mm selector switch with maintained two-position action, 1NO/1NC contacts rated 10 A at 600 V, NEMA 4/4X/13 and IP65 protection
- 30 mm mounting fits standard panels
- IP65 and NEMA 4X ratings protect against dust and water
- 10 A at 600 V AC/DC handles demanding circuits
- Two-position maintained action gives reliable on/off control
- 1NO/1NC contacts simplify wiring for safety circuits
30 mm Selector Switch for Industrial Panels
This Dayton 32UK01 is a non-illuminated selector switch with a 30 mm mounting diameter. It suits control panels, motor starters and safety disconnect enclosures. The extended lever operator provides clear tactile feedback for gloved operation. Rated for 10A at 600V AC/DC, it fits standard industrial voltage levels.
Replaces Worn Cam Switches in Maintained Circuits
The switch uses a Cam E configuration with maintained action at both Position A and Position B. It upgrades older units that have lost positive detent or show contact erosion. The jump is worth it when the existing operator feels loose or the contact block no longer holds its NEMA A600/Q600 rating. The 1NO/1NC contact form matches common legacy wiring.
NEMA 13 and IP65 Define Environmental Limits
The plastic bezel and operator head meet NEMA 4, 4X and 13 ratings alongside IP65 ingress protection. This covers hose-directed water, oil and non-corrosive coolants. It does not withstand prolonged submersion or highly corrosive atmospheres. The basic plastic construction also limits use in high-impact zones where metal operators are specified.
Highlights
- 30 mm mounting fits standard panels
- IP65 and NEMA 4X ratings protect against dust and water
- 10 A at 600 V AC/DC handles demanding circuits
- Two-position maintained action gives reliable on/off control
- 1NO/1NC contacts simplify wiring for safety circuits
Specifications
| Brand | DAYTON |
|---|
Questions about this item
What panel cut-out does the 30 mm selector switch need?
The operator requires a standard 30 mm mounting hole for installation in a control panel.
How do I wire the 1NO/1NC contacts and which position is which?
Position A gives an XO state (normally open closed, normally closed open) and Position B gives OX; tighten the screw terminals to 10 A at 600 V AC/DC.
Will the IP65 seal need replacement after heavy wash-down cycles?
The NEMA 4X and IP65 rated bezel is moulded into the operator head, so the seal is not a separate replaceable part.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
