Dayton
Dayton 2X951 Grinding Wheel Dresser 1-1/4 inch
Dresses grinding wheels up to one inch wide using a 1-1/8 inch steel spur cutter
- Restores wheel profile with spur cutter design
- Works on straight wheels 1/2 to 1 inch wide
- Steel cutter resists wear during repeated dressing
- Compact 8-1/2 inch length fits tight workspaces
- Free shipping on orders of $75 or more
Grinding Wheel Dresser for Bench Grinders
The Dayton 2X951 is a cutter-style spur dresser made to true and clean straight abrasive wheels on bench or pedestal grinders. It suits maintenance technicians, tool-room staff and metalworkers who need to restore cutting performance without replacing the wheel.
Manual Operation Keeps Heat and Noise Low
Because the tool is hand-fed against a spinning wheel, it adds no electrical load, produces no motor noise and generates only the friction heat normal to dressing. The steel cutters handle the contact forces while the operator controls pressure and feed rate directly.
Four Replaceable Steel Cutters Extend Service Life
The dresser comes with a set of four 1-1/8 inch diameter cutters, each 1/2 inch wide, that can be rotated or swapped when worn. This reduces downtime and avoids the cost of buying a whole new dressing tool when the cutting edges dull.
Highlights
- Restores wheel profile with spur cutter design
- Works on straight wheels 1/2 to 1 inch wide
- Steel cutter resists wear during repeated dressing
- Compact 8-1/2 inch length fits tight workspaces
- Free shipping on orders of $75 or more
Specifications
| Brand | DAYTON |
|---|
Questions about this item
How do I install the Dayton 2X951 dresser on my bench grinder, and what is the common mistake?
Mount the dresser so the steel spur cutters contact the wheel face squarely; the step most users miss is setting the tool rest to keep the 1/2 in cutter face fully engaged across the wheel width.
What part of the dresser will need replacement after extended use?
The steel spur cutters wear down with repeated dressing; once the cutter edges dull or the 1/8 in diameter reduces noticeably, the dresser must be replaced.
What is the first limitation I will hit when dressing wheels continuously?
The dresser only accepts straight wheels between 1/2 in and 1 in wide; wider or tapered wheels cannot be dressed with this tool.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
