Dayton
Dayton 2VKJ2 Wire Rope Clip 1/4 in Malleable Iron Yard Tool
A malleable-iron U-bolt clip secures 1/4-inch wire rope with a minimum of three clips and 12 ft-lb torque
- TypeHoists, Winches & Rigging
- Malleable iron construction delivers high strength for rigging tasks
- Galvanised finish protects against corrosion in outdoor environments
- U-bolt design provides secure grip on 1/4 inch wire rope
- Minimum three clips required for proper termination safety
- 12 ft-lb torque specification ensures reliable fastening performance
1/4 in Malleable Iron Wire Rope Clip
This Dayton wire rope clip is a galvanised U-bolt fitting made from malleable iron for 1/4 in diameter rope. It supplies a single clip for light rigging, winching or hoisting tasks where a simple mechanical splice is required. The component meets the minimum three-clip guideline for a secure termination. It carries California Proposition 65 warnings for cancer and reproductive harm.
Upgrade from fibre or plastic fasteners
Metal U-bolt clips replace rope thimbles, soft shackles or synthetic straps when a reusable, adjustable connection is needed. The jump is worth it when the load demands a galvanised iron grip that resists UV degradation and can be re-torqued to 12 ft-lb after initial seating. Plastic or fibre alternatives cannot match the clamping force or the 4 3/4 in turn-back length this clip enforces.
Single-clip capacity and headroom
One clip provides a portion of the three-clip minimum for a full eye splice on 1/4 in rope. It comfortably handles light tensioning, guy lines or temporary stays where the load stays well below the rope’s rated breaking strength. The installation runs out when the application requires the full complement of clips, higher torque values or a larger rope diameter than the 1/4 in specification.
Highlights
- Malleable iron construction delivers high strength for rigging tasks
- Galvanised finish protects against corrosion in outdoor environments
- U-bolt design provides secure grip on 1/4 inch wire rope
- Minimum three clips required for proper termination safety
- 12 ft-lb torque specification ensures reliable fastening performance
Specifications
| Brand | DAYTON |
|---|---|
| Type | Hoists, Winches & Rigging |
Questions about this item
What rope diameter does the 1/4 in clip fit?
The clip is sized for 1/4 in wire rope and requires a turn-back of 4 3/4 in per clip.
How do I tighten the U-bolt correctly?
Torque the nuts to at least 12 ft-lb and use a minimum of three clips spaced along the turn-back.
When should the clip be replaced?
Inspect for wear, deformation or corrosion on the malleable iron body and replace if any damage is found.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
