Dayton
Dayton 2RYN6 Belt Grinder 0.5 hp 42 in Belt 800 SFPM 120/240 V
Benchtop belt grinder with 0.5 hp motor runs 42 in belts at 800 SFPM on 120/240 V single-phase power
- TypeSanders
- 5 hp motor drives 800 SFPM belt speed for rapid material removal
- 42 in belt length covers large workpieces in a single pass
- 120/240 V dual-voltage operation fits standard shop wiring
- 1 in belt width with horizontal and vertical orientation handles metal, plastic and wood
- 2 in dust port keeps the work area clean during grinding
Belt Grinder for Metal, Plastic and Wood
This benchtop belt grinder runs on 120 V or 240 V single-phase power with a 0.5 hp motor. A 42 in by 1 in belt moves at 800 SFPM on a fixed-speed setting. The unit mounts horizontally or vertically and includes a 3 in by 3 in work table and a 2 in dust collection port.
Thermals, Noise and Power Draw
The motor draws 2.5 A at 240 V and 5 A at 120 V through a 6 ft cord. Steel cabinet construction helps dissipate heat during normal use. No decibel rating or thermal specification is provided in the data.
Behaviour Under Sustained Load
Fixed belt speed and single-phase power deliver consistent material removal over long sessions. The 0.5 hp rating defines continuous capacity rather than a short-burst peak. Proposition 65 warnings note chemicals linked to cancer and reproductive harm.
Highlights
- 5 hp motor drives 800 SFPM belt speed for rapid material removal
- 42 in belt length covers large workpieces in a single pass
- 120/240 V dual-voltage operation fits standard shop wiring
- 1 in belt width with horizontal and vertical orientation handles metal, plastic and wood
- 2 in dust port keeps the work area clean during grinding
Specifications
| Type | Sanders |
|---|---|
| Brand | Dayton |
| Model | 2RYN6 |
Questions about this item
How do I mount the 42 in belt grinder on a bench and wire it for 120 V or 240 V single-phase?
Bolt the steel cabinet to a solid benchtop using the mounting holes, then connect the 6 ft cord to a 120 V or 240 V single-phase supply rated for 2.5 A or 5 A respectively; the motor runs at 0.5 hp and the belt tracks at 800 SFPM once powered.
What parts will need replacement after extended use on metal, plastic or wood?
The 1 in wide by 42 in long abrasive belt wears first; keep spares matching that length and width. The 2 in dust port can clog, so clean it regularly, and inspect the drive pulley and tracking mechanism for wear during belt changes.
At what point does the fixed 800 SFPM speed limit material removal during long grinding sessions?
The single-speed motor delivers 800 SFPM continuously; heat buildup in the workpiece and belt loading become the practical limits before the 0.5 hp motor stalls, especially on harder metals.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
