We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass solenoid valve body, 1/4 in pipe, normally closed

Dayton

Dayton 2CZZ2 Brass Solenoid Valve Trap 1/4 in 0.48 Cv 100 psi 180°F

SKU CH-F86T-XGPKW MPN 2CZZ2

A brass solenoid valve body with 1/4 in pipe size, 0.48 Cv flow capacity, 100 psi pressure rating and 180°F maximum fluid temperature

  • TypeDrain Components
  • Brass body resists corrosion in water and air lines
  • 48 Cv flow coefficient matches low-volume drain requirements
  • 100 psi pressure rating handles typical pneumatic and water systems
  • 180 °F maximum fluid temperature suits hot condensate return
  • Normally closed design prevents flow until energised for safety

Valve body and intended use

The Dayton 2CZZ2 is a brass solenoid valve body designed for drain and trap applications. It operates in a normally closed, two-way, two-position configuration with a 1/4 inch nominal pipe size and a 0.48 Cv flow coefficient. The valve handles air, inert gas, or water up to 100 psi differential pressure and fluid temperatures up to 180 degrees Fahrenheit, rated for indoor or outdoor environments.

Compatibility checks before ordering

Verify that your system uses a 1/4 inch pipe connection and requires a normally closed valve that opens when energised. The orifice diameter is 5/32 inch and the body is brass, so confirm fluid compatibility with your media. Note that this listing is for the valve body less coil; you must supply a compatible coil separately to actuate the valve.

Thermal, noise and power characteristics

The brass body withstands fluid temperatures up to 180 degrees Fahrenheit in continuous operation. As a passive valve body without an integrated coil, it produces no electrical noise or heat of its own; thermal load and audible actuation depend entirely on the coil you install. Power draw is determined by the separate coil specification.

Highlights

  • Brass body resists corrosion in water and air lines
  • 48 Cv flow coefficient matches low-volume drain requirements
  • 100 psi pressure rating handles typical pneumatic and water systems
  • 180 °F maximum fluid temperature suits hot condensate return
  • Normally closed design prevents flow until energised for safety

Specifications

TypeDrain Components
BrandDayton
Model2CZZ2

Questions about this item

Does the brass body include the solenoid coil or do I need to order it separately?

The listing is for the valve body only; the coil is sold separately and must match your voltage requirement.

How do I decide between the 0.48 Cv rating and a higher-flow alternative?

Choose the 0.48 Cv version when controlling small-bore lines up to 1/4 in where precise low-volume metering is needed.

Will the 100 psi air rating hold if the line sees short pressure spikes above that value?

The maximum operating differential is 100 psi for air or inert gas; sustained or repeated spikes above this limit are not covered by the rating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.