Dayton
Dayton 1DLG9 Wire Rope Thimble 3/16 In 304 Stainless Steel Pack of 25
Protects 3/16 in wire rope loops with 304 stainless steel thimbles, pack of 25
- TypeAngle, Pitch & Slope Locators
- 304 stainless steel resists corrosion in harsh environments
- 3/16 inch rope diameter matches common lifting applications
- Open-end design allows quick installation on wire rope
- Pack of 25 covers multiple rigging points
- 1 7/16 inch loop inside length fits standard hardware
Wire Rope Thimble 3/16 In 304 Stainless Steel
The Dayton 1DLG9 wire rope thimble protects 3/16 in rope eyes from wear and deformation. Made from 304 stainless steel with a plain finish, each piece measures 1 15/16 in overall length by 1 1/8 in overall width. The open-end design suits lifting applications where a closed ferrule is not required. Pack of 25 supports volume rigging work.
Thermals Noise and Power Draw
This is a passive stainless steel fitting with no moving parts, electronics or power consumption. It generates no heat and produces no audible noise during installation or service. The 304 alloy resists corrosion in marine and industrial environments without additional coatings. Wall thickness of 1/32 in maintains structural integrity under normal lifting loads.
Replaces Worn Thimbles in Existing Assemblies
Use these to replace damaged or corroded thimbles on 3/16 in wire rope slings and pendant lines. The inside loop dimensions of 1 7/16 in by 23/32 in match standard hardware sizing for shackles and hooks. The jump is worth it when inspections reveal flattened walls, cracked eyes or heavy surface pitting on current thimbles. Not for ropes larger than 3/16 in or applications requiring certified load ratings beyond the material yield.
Highlights
- 304 stainless steel resists corrosion in harsh environments
- 3/16 inch rope diameter matches common lifting applications
- Open-end design allows quick installation on wire rope
- Pack of 25 covers multiple rigging points
- 1 7/16 inch loop inside length fits standard hardware
Specifications
| Brand | Dayton |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
How do I install the 3/16 in thimble and what step is often missed?
Slide the rope through the 1 7/16 in inside loop, form the eye around the thimble, then secure with properly sized wire rope clips; the step often missed is retorquing the clips after the first load cycle.
What maintenance or replacement will the 304 stainless steel thimbles need later?
Inspect each thimble for deformation, corrosion pitting or wear at the 1/32 in wall thickness; replace any piece that shows elongation of the 23/32 in inside width or cracking at the open end.
What limit appears first on the 3/16 in thimble under sustained lifting use?
The 1/32 in wall thickness at the 1 15/16 in overall length yields before the 304 stainless material reaches its corrosion limit, so plastic deformation of the loop is the first failure mode.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
