Cyclone
Cyclone Xd 5X Solid Double Margin Drill 5.80mm
Solid double-margin drill cuts precise 5.80 mm holes with five-times diameter reach
- 5X diameter design enables deeper holes in a single pass
- Solid carbide construction resists wear for longer tool life
- Double margin geometry improves hole straightness and finish
- 80 mm cutting diameter matches precise drilling requirements
- California Proposition 65 warning indicates regulated chemical content
Cyclone Xd 5X Drill 5.80mm
This solid double margin drill is designed for precision hole-making in demanding materials. It suits machinists and fabricators who need consistent accuracy and tool life. The 5.80mm diameter fits specific pilot or clearance requirements. It is not for general-purpose drilling in soft woods or plastics where standard twist drills suffice.
Capacity and headroom at 5.80mm
The 5X designation indicates a flute length suited for depths up to five times the diameter. The double margin design improves hole straightness and surface finish in deeper cuts. It handles alloy steels and hardened materials within its recommended speed range. The drill runs out when hole depth exceeds the flute capacity or when coolant delivery cannot reach the tip.
Practical limits of the solid carbide interface
Solid carbide construction provides rigidity but is brittle under interrupted cuts or heavy run-out. The tool requires a rigid machine spindle and secure workholding to prevent chipping. California Proposition 65 warnings apply due to chemical content in the coating or substrate. It is not for hand-held use or unstable fixturing where deflection occurs.
Highlights
- 5X diameter design enables deeper holes in a single pass
- Solid carbide construction resists wear for longer tool life
- Double margin geometry improves hole straightness and finish
- 80 mm cutting diameter matches precise drilling requirements
- California Proposition 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 5.80 mm Cyclone Xd 5X drill work with my existing 1/4 inch collet?
The 5.80 mm shank is slightly larger than a 1/4 inch collet opening, so you will need a 6 mm or metric collet for proper grip.
How can I confirm the Cyclone Xd 5X is cutting correctly after install?
Check for a steady, quiet cut with even chip formation and measure the hole diameter — it should match the 5.80 mm spec within normal tolerance.
Does the Cyclone Xd 5X 5.80 mm drill come with a case or coolant accessory?
The item ships as the drill only; no case, coolant or extra accessories are included in the box.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
