Cyclone
Cyclone Xd 5X Solid Double Margin Drill 5.40mm pneumatic accessory
Solid double-margin drill bit cuts precise 5.40 mm holes in pneumatic applications
- 5x solid double-margin design for superior hole straightness
- 40 mm cutting diameter for precise sizing
- Cyclone Xd coating extends tool life in tough materials
- Optimised flute geometry improves chip evacuation
- California Proposition 65 warning for cancer and reproductive harm
Cyclone Xd 5X Drill 5.40mm
The Cyclone Xd 5X Solid Double Margin Drill is a pneumatic accessory designed for precision drilling tasks. It suits engineers and machinists who need consistent hole quality in demanding materials. The 5.40mm diameter targets specific production requirements.
Thermals noise and power draw
The tool operates on compressed air, so electrical power draw is not a factor during use. Heat generation stays low because the cutting action relies on pneumatic rotation rather than an electric motor. Noise levels follow the air supply and the workpiece material.
Build quality and daily use
The solid double margin design supports hole straightness and surface finish in repetitive operations. California Proposition 65 warnings note that the product contains chemicals known to cause cancer and reproductive harm. Users should follow shop safety procedures and wear appropriate protective equipment.
Highlights
- 5x solid double-margin design for superior hole straightness
- 40 mm cutting diameter for precise sizing
- Cyclone Xd coating extends tool life in tough materials
- Optimised flute geometry improves chip evacuation
- California Proposition 65 warning for cancer and reproductive harm
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 5.40 mm Cyclone Xd 5X drill in a pneumatic tool, and what step is often missed?
Insert the shank fully into the collet, tighten the chuck securely, then verify the double margins run true before starting the air supply.
What maintenance or replacement will the 5.40 mm Cyclone Xd 5X drill need later?
Resharpen or replace the drill when the cutting edges dull or the double margins show wear that affects hole quality.
What limit appears first on the 5.40 mm Cyclone Xd 5X drill under sustained use?
Heat buildup at the cutting edges and margin wear will limit continuous drilling before the tool body fails.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
