Cyclone
Cyclone Xd 3X Solid Double Margin Drill 12.90Mm
Solid double-margin drill bit, 12.90 mm diameter, for precise deep-hole drilling
- Solid double margin design improves hole accuracy
- 3X flute geometry enhances chip evacuation
- 90 mm diameter suits precise drilling tasks
- New condition ensures full factory performance
- M.A. Ford manufacturing delivers professional-grade reliability
Cyclone Xd 3X Solid Double Margin Drill 12.90Mm
The Cyclone Xd 3X Solid Double Margin Drill is a 12.90 mm cutting tool built for precision holemaking in demanding materials. Its solid construction and double margin design support accurate drilling for machinists and maintenance professionals who need consistent results.
Thermals noise and power draw in normal use
The drill operates with standard heat generation typical for solid carbide tooling at recommended speeds. Noise levels remain within expected ranges for rotary cutting, and power consumption matches the machine spindle requirements for a 12.90 mm diameter tool.
Sustained load behaviour rather than short burst
Under continuous cutting the double margin geometry helps maintain hole straightness and surface finish over extended cycles. The solid carbide body resists deflection and wear, allowing the drill to hold tolerance during long production runs without premature degradation.
Highlights
- Solid double margin design improves hole accuracy
- 3X flute geometry enhances chip evacuation
- 90 mm diameter suits precise drilling tasks
- New condition ensures full factory performance
- M.A. Ford manufacturing delivers professional-grade reliability
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 12.90 mm Cyclone Xd 3X Solid Double Margin Drill and what step is often missed?
Chuck the drill securely in a compatible drill press or handheld drill, ensure the shank seats fully, and apply steady feed pressure; the step often missed is verifying spindle run-out before cutting to prevent premature margin wear.
What maintenance or replacement will the 12.90 mm Cyclone Xd 3X Solid Double Margin Drill need over time?
The solid carbide construction requires no sharpening schedule; replace the drill once the double margins show measurable wear or hole tolerance exceeds specification, typically after extensive use in abrasive materials.
What limit appears first on the 12.90 mm Cyclone Xd 3X Solid Double Margin Drill during sustained drilling?
Heat buildup at the cutting edges is the first limiting factor; without adequate coolant or peck cycles, the 12.90 mm diameter can overheat, reducing tool life and hole quality in deep-hole applications.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
