Cyclone
Cyclone Xd 3X Solid Double Margin Drill 12.83mm
Solid double-margin drill bit, 12.83 mm diameter, for precise power-tool drilling
- 83 mm diameter fits precise hole sizes
- Solid carbide construction resists wear in tough materials
- Double margin design improves hole straightness and finish
- 3× flute geometry enhances chip evacuation
- M.A. Ford quality backs reliable drilling performance
12.83 mm solid double-margin drill
The Cyclone Xd 3X drill is a solid carbide cutting tool with a 12.83 mm diameter and a double-margin design. It is intended for precision drilling operations where hole accuracy and surface finish are critical. Machinists and fabricators select it for consistent performance in production environments.
Thermal behaviour and power draw
The double-margin geometry helps stabilise the drill in the cut, which reduces vibration and distributes cutting forces evenly across both margins. This stability lowers heat concentration at the cutting edges during normal drilling cycles. Reduced vibration also contributes to quieter operation compared with single-margin alternatives.
Shank fit and daily implications
The solid carbide construction provides high rigidity and wear resistance for extended tool life in abrasive materials. A cylindrical shank allows direct clamping in standard drill holders or collets without additional adapters. The tool carries a California Proposition 65 warning for chemicals linked to cancer and reproductive harm, so appropriate handling procedures are required.
Highlights
- 83 mm diameter fits precise hole sizes
- Solid carbide construction resists wear in tough materials
- Double margin design improves hole straightness and finish
- 3× flute geometry enhances chip evacuation
- M.A. Ford quality backs reliable drilling performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 12.83mm Cyclone Xd 3X drill in my drill press, and what step do people often get wrong?
Clamp the workpiece securely, select the correct speed for the material, and apply steady feed pressure; the step most often missed is using cutting fluid to prevent overheating and premature wear.
What maintenance or replacement will the 12.83mm Cyclone Xd 3X drill need over time?
The solid carbide cutting edges will dull with use; resharpening by a specialist grinder restores geometry, but once the double margins wear down the drill must be replaced.
What limit appears first when the 12.83mm Cyclone Xd 3X drill runs continuously in hard steel?
Heat buildup at the cutting lips is the first limiting factor; without adequate coolant the carbide can overheat, causing edge breakdown and loss of hole accuracy.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
