Corrosionx
CorrosionX 96004 Corrosion Inhibitor Fluid 1 gal Jug Mineral Oil Base 200 Degrees
Mineral-oil corrosion inhibitor protects metal up to 200 °F in a one-gallon jug
- Mineral-oil base protects metal up to 200 °F
- Low 9 % VOC content reduces airborne emissions
- Flash point 212 °F adds high-temperature safety margin
- Meets ASTM B117, D1748 and D877 test standards
- Operates down to –10 °F for cold-environment reliability
CorrosionX 96004 Inhibitor Jug
CorrosionX 96004 is a mineral-oil-based corrosion inhibitor supplied in a one-gallon jug. It forms a wet lubricant film that protects metal surfaces in machinery and machine-shop environments. The fluid operates from minus ten degrees Fahrenheit up to two hundred degrees Fahrenheit. It meets ASTM B117, D1748 and D877 test standards.
Suited for general indoor and outdoor protection
The product suits maintenance teams needing medium life expectancy indoors and outdoors with moderate removability. It is not intended for applications requiring an NSF-rated lubricant or a non-mineral-oil chemical base. Buyers who need a food-grade rating or a different base chemistry should look at alternative fluids.
Behaviour under sustained heat and exposure
With a flash point of two hundred twelve degrees Fahrenheit and a maximum operating temperature of two hundred degrees Fahrenheit, the fluid remains stable during prolonged high-temperature operation. Its specific gravity of zero point nine one and nine percent VOC content stay consistent over extended use. The wet film continues to resist corrosion during long indoor or outdoor exposure cycles.
Highlights
- Mineral-oil base protects metal up to 200 °F
- Low 9 % VOC content reduces airborne emissions
- Flash point 212 °F adds high-temperature safety margin
- Meets ASTM B117, D1748 and D877 test standards
- Operates down to –10 °F for cold-environment reliability
Specifications
| Brand | CORROSIONX |
|---|
Questions about this item
What surfaces or equipment must I already have to apply the 1 gal jug of CorrosionX 96004?
The fluid is a mineral-oil-based corrosion inhibitor that can be brushed, sprayed or dipped onto clean metal parts; you only need a suitable applicator and the components you want to protect.
Will the inhibitor remain effective on machinery that sees temperatures up to 200 Degrees F?
Yes, the product is rated for a maximum operating temperature of 200 Degrees F and a minimum of -10 Degrees F, so it stays active across that range.
How can I verify the fluid is performing after I coat a part?
A protected surface should show no rust after exposure to moisture or salt spray; the ASTM B117 salt-fog and ASTM D1748 humidity tests are the standard benchmarks used to confirm performance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
