We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black and yellow striped anti-slip tape rolls, 2 inch width, 60 foot length, grit 46 texture, pack of six

Condor

Condor Antislip Tape 2 in x 60 ft Black Yellow Grit 46 Pack 6

SKU CH-BJFY-N7TTK

Black and yellow anti-slip tape with 46 grit aluminium oxide, 2 in wide by 60 ft long, rated from -20 °F to 150 °F, NSFI certified, six rolls

  • High-traction grip from 46-grit aluminum oxide surface
  • Reliable hold with 75 oz/in acrylic adhesive strength
  • Withstands -20 to 150 degrees F for indoor or outdoor use
  • NSFI certified for high-traction safety compliance
  • Six continuous 60 ft rolls provide extended coverage

Industrial Safety Tape for Hazard Marking

Condor GRAN15292 antislip tape delivers a black-and-yellow striped surface with aluminum-oxide grit 46 bonded to a continuous roll. Each roll measures 2 in wide by 60 ft long and 0.03 in thick, supplied in a pack of six for facility-wide deployment.

Replaces Worn Floor Markings and Smooth Surfaces

The acrylic adhesive rated at 75 oz/in bonds to concrete, metal or wood, upgrading areas where paint or lesser tapes have failed. The jump is worth it when a surface must stay slip-resistant from -20 degrees to 150 degrees F indoors or outdoors.

Limits of the Grit-and-Adhesive System

Grit 46 provides aggressive traction but will abrade soft-soled footwear faster than finer grades. Adhesion drops on oily, dusty or wet substrates unless cleaned first, and the 3 in roll diameter requires a dispenser or hand space for application.

Highlights

  • High-traction grip from 46-grit aluminum oxide surface
  • Reliable hold with 75 oz/in acrylic adhesive strength
  • Withstands -20 to 150 degrees F for indoor or outdoor use
  • NSFI certified for high-traction safety compliance
  • Six continuous 60 ft rolls provide extended coverage

Specifications

BrandCONDOR

Questions about this item

What surface preparation and pressure are required for the 75 oz/in acrylic adhesive to bond properly?

Clean the surface until it is dry and free of oil, dust or loose paint, then apply firm even pressure along the full 2 in width so the acrylic adhesive wets out completely; skipping the pressure step is the most common cause of edge lift.

How do I align and apply a continuous 60 ft roll without trapping air bubbles?

Unroll a short section, position the black/yellow striped edge, then use a hand roller or squeegee to press the tape down progressively while peeling the liner, keeping the 0.03 in thick grit layer flat against the floor.

When should the grit 46 aluminum oxide surface be replaced in a high-traffic aisle?

Replace the tape once the striped pattern wears smooth or the 75 oz/in adhesive shows edge lift; in heavy forklift lanes this typically occurs after the surface no longer meets the NSFI high-traction rating.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.