CMT
CMT 840.850.11 Roman Ogee Router Bit 1-1/2 in
A carbide-tipped Roman ogee router bit with a 1-1/2 inch cutter diameter and 1/2 inch shank
- Roman ogee profile cuts decorative edges
- Carbide tips stay sharp through repeated use
- 1-1/2 inch cutter diameter shapes wide profiles
- 1/2 inch shank fits standard router collets
- CMT brand trusted by woodworking professionals
CMT Roman Ogee Router Bit
This CMT Roman Ogee router bit cuts a classic double-curve profile in a single pass. The carbide-tipped cutter measures 1-1/2 inches in diameter and is designed for use in a router table or handheld router with a 1/2 inch collet. It produces clean, decorative edges on hardwood, softwood and man-made board.
Woodworkers adding traditional moulding detail
The bit suits cabinetmakers, furniture builders and hobbyists who need a precise Roman Ogee shape for edge forming or period-style trim. It is not intended for metal, masonry or plastics, and it cannot cut profiles other than the fixed Ogee geometry. Buyers needing variable profiles or bearing-guided flush trimming should select a different tool.
1-1/2 inch cutter diameter
The 1-1/2 inch cutter diameter determines the maximum width and depth of the Ogee profile produced in one pass. A 1/2 inch shank provides the rigidity required for this cutter size, reducing vibration and ensuring a smooth finish on the workpiece.
Highlights
- Roman ogee profile cuts decorative edges
- Carbide tips stay sharp through repeated use
- 1-1/2 inch cutter diameter shapes wide profiles
- 1/2 inch shank fits standard router collets
- CMT brand trusted by woodworking professionals
Specifications
| Brand | CMT |
|---|
Questions about this item
Will the 1/2 in shank fit the collet of my older router that only takes 1/4 in bits?
The bit uses a 1/2 in shank, so it requires a 1/2 in collet or a compatible reducer sleeve; a 1/4 in collet will not accept it.
How can I confirm the 11/16 in cutting depth is producing the correct Roman ogee profile on my test piece?
Route a scrap board and measure the profile depth with a dial caliper; it should read 11/16 in at the deepest point of the ogee curve.
Does the 840.850.11 come with a bearing guide or wrench, or must I buy them separately?
The supplied package contains only the carbide-tipped router bit; bearing guides, collet wrenches and reducers are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
