CMT
CMT 806.630.11 Flush Trim Router Bit 1/2 in Cutter 2 in Cut Length
Carbide-tipped flush-trim router bit with a half-inch cutter and two-inch cutting length
- TypeRouters
- Weight0.25
- Carbide-tipped edge keeps cuts clean through hardwoods
- 1/2 in cutter diameter trims flush in a single pass
- 2 in cutting length handles thick stock without repositioning
- Light 0.25 lb weight reduces router strain during long runs
Flush Trim Router Bit 1/2 in Cutter
The CMT 806.630.11 is a carbide-tipped flush trim router bit built for trimming laminate, veneer or solid-wood edging flush to a substrate. Its 1/2 inch cutter diameter and 2 inch cut length suit hand-held or table-mounted routers in cabinet and furniture shops. The bit weighs 0.25 units and arrives new.
Check shank fit and bearing clearance
Verify your router collet accepts a 1/2 inch shank before ordering. Confirm the workpiece thickness does not exceed the 2 inch cut length. Ensure the guide bearing can rotate freely and that the tool’s overall length of 4 3/32 inches clears your router base and any fixtures.
Highlights
- Carbide-tipped edge keeps cuts clean through hardwoods
- 1/2 in cutter diameter trims flush in a single pass
- 2 in cutting length handles thick stock without repositioning
- Light 0.25 lb weight reduces router strain during long runs
Specifications
| Type | Routers |
|---|---|
| Weight | 0.25 |
| Brand | Cmt |
Questions about this item
Does the CMT 806.630.11 router bit include a bearing or collet in the package?
The bit is supplied as a single carbide-tipped cutter; bearings and collets are sold separately.
Should I choose the 1/2 in cutter diameter or a different size for this model?
This model 806.630.11 is only offered with a 1/2 in cutter diameter and 2 in cut length.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
