CMT
CMT 801.127.11 Hinge Mortise Router Bit 1/2 in
Carbide-tipped hinge mortise router bit cuts 1/2 in diameter clean mortises for door hardware installation
- Carbide tipped for long edge life
- 1/2 in cutter diameter suits standard hinges
- 3/4 in cutting depth handles typical mortises
- 2 1/8 in overall length gives good reach
- 1/4 in shank fits common routers
CMT 801.127.11 Hinge Mortise Router Bit
This carbide-tipped router bit produces clean hinge mortises in wood. The 1/2 inch shank fits standard collets on mid-size and full-size routers. Woodworkers installing doors or cabinet hardware will find the profile matches common butt-hinge dimensions.
Replaces straight bits and chisel work for mortising
A dedicated mortise bit cuts the full profile in one pass, removing the need to hog out waste with a straight bit and square the corners by hand. The upgrade is worth it when you cut multiple mortises per project and want repeatable depth and crisp edges without layout lines.
Verify your router accepts a 1/2 inch shank
Confirm the collet size and that the motor can handle the cutter diameter at the recommended speed. Check that the workpiece thickness suits the cutting length and that you have a fence or template guide for consistent positioning.
Highlights
- Carbide tipped for long edge life
- 1/2 in cutter diameter suits standard hinges
- 3/4 in cutting depth handles typical mortises
- 2 1/8 in overall length gives good reach
- 1/4 in shank fits common routers
Specifications
| Brand | CMT |
|---|
Questions about this item
What shank size does the 801.127.11 hinge mortise bit need in the router collet?
The bit uses a standard 1/4 in shank that fits common router collets.
How do you set the 801.127.11 bit depth so the hinge sits flush without cutting too deep?
Adjust the router depth stop to match the hinge leaf thickness, then test on scrap before mortising the door.
When should the carbide cutters on the 801.127.11 bit be sharpened or replaced?
Replace or sharpen when the cutters leave tear-out, burn marks, or require excessive feed pressure.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
