We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Climax Metal Products steel shaft collar set screw 1 inch bore 5/8 inch width

Climax Metal Products

Climax Metal Products Shaft Collar C-100-BO 100

SKU CH-BX46-H8QG2

Steel shaft collar with a one-inch bore and set-screw fastening

  • Shaft collar with 1 in bore fits 100 mm shafts
  • Set-screw locking holds position without marring the shaft
  • Steel construction resists wear in yard-tool applications
  • One-inch borediameter suits standard pruning equipment shafts

Shaft Collar with 1in Bore

The Climax Metal Products shaft collar uses a set-screw design to lock onto a shaft with a 1in bore. It suits maintenance crews and machinery builders who need a simple axial stop or spacer component. The steel construction provides the rigidity required for general-purpose positioning tasks. No specialised tooling is needed for installation.

Capacity and headroom

The 5/8in width gives enough bearing surface for light-to-moderate axial loads in conveyors, jigs or adjustable assemblies. It runs out when the application demands high clamping force, vibration resistance or repeated repositioning without shaft marking. Buyers needing keyless locking, quick-release action or corrosion-resistant finishes must look elsewhere.

Highlights

  • Shaft collar with 1 in bore fits 100 mm shafts
  • Set-screw locking holds position without marring the shaft
  • Steel construction resists wear in yard-tool applications
  • One-inch borediameter suits standard pruning equipment shafts

Specifications

BrandClimax Metal Products

Questions about this item

Will the 1 in bore fit the shaft I already have?

The collar is bored to 1 in, so it matches a 1 in shaft. Measure your shaft to confirm the fit.

How do I know the set screw is holding properly after installation?

Tighten the set screw until the collar cannot rotate or slide on the shaft, then re-check after the first few minutes of use.

More in Cutting, Edging & Pruning

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.