Cleveland Golf
Cleveland Golf End Mill HSS 1 in 2 Flute Single End Square Center Cutting 30 Deg
A 1-inch high-speed steel end mill with two flutes, single square end, center-cutting geometry and 30-degree helix for plunge cutting, peripheral milling and deep slotting
- TypeHole, Drill, Bore & Wire Gauges
- High-speed steel construction resists wear during general-purpose milling
- Two-flute design clears chips efficiently in deep slots and pockets
- Center-cutting geometry allows direct plunge cuts into the workpiece
- Single-end square profile creates flat-bottom features with sharp corners
- Bright finish reduces friction and helps prevent built-up edge
End Mill HSS 1 Inch 2 Flute
This end mill is a standard general-purpose tool made from high speed steel with a bright finish. It features a single end with a square profile and center cutting design. The tool has a 1 inch cutting diameter and a 3/4 inch shank diameter. It is intended for plunge cutting, peripheral milling, deep slotting and pocketing operations.
Right Hand Cut 30 Degree Helix
The right hand cut configuration with 30 degree helix angles on both radial and axial planes provides consistent chip evacuation during milling. A single end design means the cutting geometry is concentrated on one end of the tool. The high speed steel construction offers toughness suitable for a range of workpiece materials in general machining applications.
General Purpose Machining Limits
High speed steel tools like this end mill are practical for general purpose milling but have lower heat resistance than carbide alternatives. The tool is restricted from sale in certain states as noted by the supplier. Buyers needing higher cutting speeds or extended tool life in abrasive materials should evaluate carbide options instead.
Highlights
- High-speed steel construction resists wear during general-purpose milling
- Two-flute design clears chips efficiently in deep slots and pockets
- Center-cutting geometry allows direct plunge cuts into the workpiece
- Single-end square profile creates flat-bottom features with sharp corners
- Bright finish reduces friction and helps prevent built-up edge
Specifications
| Brand | Cleveland |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
What does the 30-degree helix angle mean for chip evacuation?
The 30-degree helix angle balances chip evacuation and tool rigidity for general-purpose milling in steel and non-ferrous materials.
What are the shank and cutting diameters required for toolholder clearance?
The cutting diameter is 1 inch and the shank diameter is 3/4 inch, so the holder must accommodate a 3/4-inch shank with at least 1-inch clearance for the flutes.
How do I set up this center-cutting end mill for a plunge cut?
Use the center-cutting geometry to plunge directly into the workpiece at reduced feed, then transition to peripheral milling or slotting once full depth is reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
