Cleveland Golf
Cleveland Golf End Mill Cobalt 3/8 4 FL SGL Sq End CC
A 3/8-inch cobalt square end mill with four flutes and centre-cutting design for general milling operations
- TypeHole, Drill, Bore & Wire Gauges
- 4-flute design enables efficient material removal and smooth finishes
- Cobalt construction resists heat and wear for longer tool life
- 3/8" diameter suits a range of milling tasks
- Center-cutting capability allows plunge cuts and pocketing
- 2-1/2" overall length provides reach and rigidity
Cleveland Cobalt End Mill 3/8" 4-Flute
The Cleveland Golf end mill is a cobalt square-end cutter with a 3/8 inch diameter and four flutes. It is designed for general-purpose milling in ferrous and non-ferrous materials where cobalt offers improved heat resistance over high-speed steel. The centre-cutting geometry allows the tool to plunge directly into the workpiece. Overall length is 2-1/2 inches.
Machinists needing a versatile centre-cutting
This tool suits machinists and fabricators who require a single end mill for slotting, profiling and plunge cuts in steel or alloys. It is not suited for high-volume production runs where solid carbide tool life justifies the higher cost. Buyers needing ball-nose profiles for 3D contouring or a larger diameter for heavy material removal should select a different geometry.
3/8 inch diameter with centre-cutting four-flute
The 3/8 inch cutting diameter combined with four flutes and centre-cutting capability determines the tool's rigidity, chip clearance and ability to start a cut without a pre-drilled hole. This specification decides whether the cutter fits the required feature size and milling strategy for the job.
Highlights
- 4-flute design enables efficient material removal and smooth finishes
- Cobalt construction resists heat and wear for longer tool life
- 3/8" diameter suits a range of milling tasks
- Center-cutting capability allows plunge cuts and pocketing
- 2-1/2" overall length provides reach and rigidity
Specifications
| Brand | Cleveland |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
Does the 3/8 inch shank fit a standard 3/8 inch collet or end mill holder?
Yes, the 3/8 inch diameter shank is made for standard 3/8 inch collets, Weldon flats, or side-lock holders; match the holder bore exactly to avoid run-out.
What machine clearance is needed for the 2-1/2 inch overall length?
The tool measures 2-1/2 inches overall, so the spindle-to-workpiece gap must exceed that length plus the depth of cut; verify Z-travel and fixture height before machining.
How should this cobalt end mill be secured to prevent the flutes from being damaged during tool changes?
Clamp only on the smooth shank — never on the fluted cutting section — and tighten the holder evenly to avoid cracking the cobalt substrate.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
