Cleveland Golf
Cleveland Golf Cobalt Drill Bit 1/8" 135° TiAlN Parabolic 2075TA
A cobalt steel jobber drill bit with a 135-degree point and TiAlN coating for high-performance drilling
- TypeAngle, Pitch & Slope Locators
- Cobalt steel construction extends bit life
- 135° notch point starts holes without wandering
- Parabolic flutes clear chips from deep cuts
- TiAlN coating resists heat during high-speed drilling
- 2075TA jobber length suits general-purpose work
Cleveland Cobalt Drill Bit 1/8 Inch
This Cleveland Golf cobalt drill bit measures 1/8 inch with a 135-degree point angle. The TiAlN coating and parabolic flute design support efficient chip removal. It suits metalworkers and maintenance technicians who need a high-performance jobber drill for general-purpose drilling tasks.
Upgrade From Standard High-Speed Steel Bits
The cobalt steel construction and TiAlN finish increase wear resistance compared to uncoated high-speed steel alternatives. The 135-degree notch point reduces walking on hard materials. The jump is worth it when drilling stainless steel or other tough alloys that dull standard bits quickly.
Straightforward Chuck Installation
The 1/8-inch shank fits standard drill chucks without adapters. Right-hand cutting direction matches common power drills. Problems usually arise if the workpiece is not clamped securely or if cutting speed and feed are not matched to the material, leading to premature wear or breakage.
Highlights
- Cobalt steel construction extends bit life
- 135° notch point starts holes without wandering
- Parabolic flutes clear chips from deep cuts
- TiAlN coating resists heat during high-speed drilling
- 2075TA jobber length suits general-purpose work
Specifications
| Brand | Cleveland |
|---|---|
| Type | Angle, Pitch & Slope Locators |
Questions about this item
What shank diameter does the 1/8-inch drill bit use for the chuck?
The shank diameter is 1/8 inch, matching the drill bit size for a direct fit in standard three-jaw chucks.
How do I start the hole correctly with the 135-degree notch point?
Apply steady pressure at low speed; the 135-degree notch point self-centres without a centre punch, preventing walk on hard materials.
When should the TiAlN coating be considered worn and the bit replaced?
Replace the bit when the gold TiAlN coating has worn through to the cobalt substrate at the cutting lips, indicating lost heat resistance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
