Cleveland Golf
Cleveland Golf C65882 HSS Round Adjustable Die 9/16-18 UNF 1-1/2 in OD pneumatic accessory
High-speed steel adjustable threading die cuts 9/16-18 UNF threads with a 1-1/2 inch outer diameter
- TypeDies & Taps
- MaterialHigh speed steel
- Cuts precise 9/16-18 UNF threads with high-speed steel durability
- Adjustable design allows fine thread-fit control for reliable results
- 1-1/2 in outside diameter fits standard die stocks securely
- Bright uncoated finish resists corrosion during storage and use
- Right-hand threading suits common fastener applications
HSS round adjustable die 9/16-18 UNF
This high-speed-steel die cuts right-hand UNF threads with a 1-1/2 inch outside diameter and 1/2 inch thickness. The bright machined finish is uncooled for general-purpose threading. Adjustable construction allows fine control of thread fit on a lathe or by hand.
Maintenance crews and small-batch machinists
Suited for repair shops producing replacement bolts or hobbyists threading short runs in mild steel. Not for high-volume production lines that require coated carbide tooling or automated thread-rolling equipment.
9/16-18 UNF thread specification
The die is dedicated to 9/16 inch diameter with 18 threads per inch Unified National Fine form. Verify the workpiece matches this exact pitch and diameter before purchase.
Highlights
- Cuts precise 9/16-18 UNF threads with high-speed steel durability
- Adjustable design allows fine thread-fit control for reliable results
- 1-1/2 in outside diameter fits standard die stocks securely
- Bright uncoated finish resists corrosion during storage and use
- Right-hand threading suits common fastener applications
Specifications
| Brand | Cleveland |
|---|---|
| Model | C65882 |
| Type | Dies & Taps |
| Material | High speed steel |
Questions about this item
What size hex die stock or holder do I need for the 1-1/2 in outside diameter?
Use a die stock or holder that accepts a 1-1/2 in round die; the die thickness is 1/2 in so the clamping mechanism must clear that depth.
Can I thread 9/16-18 UNF into a hole previously cut with an older 9/16-18 tap?
Yes, the die cuts standard right-hand UNF threads, so it matches existing 9/16-18 UNF tapped holes provided the prior tap was on spec.
How do I verify the die is cutting a correct 9/16-18 UNF thread after setup?
Run the die on a test rod, then check the thread with a 9/16-18 UNF go/no-go ring gauge or thread a known-good 9/16-18 UNF nut onto the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
