Cleveland Golf
Cleveland Golf 44520 Lathe Tool Blank
Square high-speed steel lathe tool blank for right- or left-hand turning operations
- TypeHole, Drill, Bore & Wire Gauges
- High-speed steel construction resists wear during turning
- 1/2-inch square cross-section fits standard tool holders
- Four-inch overall length provides reach for deep cuts
- Right- and left-hand orientation suits both feed directions
- Non-bevelled profile delivers a clean starting edge
Lathe Tool Blank for Machinists
The Cleveland Golf 44520 lathe tool blank is made from high-speed steel for turning operations. It suits machinists and maintenance technicians who grind custom cutting profiles. The right-and-left-hand design allows versatile tool-bit preparation. This blank arrives ready for shaping on a bench grinder.
1/2 in Square by 4 in Length
The blank measures 1/2 inch in overall width and height with a 4-inch overall length. This cross-section provides enough material for standard lathe tool bits such as roughing, finishing and threading cutters. The non-bevelled surfaces give a clean starting point for grinding precise geometries. Longer or wider blanks are not covered by this stock size.
High-Speed Steel Grade M2
The tool blank uses M2 high-speed steel, which retains hardness at elevated cutting temperatures. This grade handles general-purpose turning of mild steel, cast iron and non-ferrous metals. It is not intended for carbide-grade wear resistance or extreme high-speed production runs. Buyers needing cobalt-enhanced grades should select a different material specification.
Highlights
- High-speed steel construction resists wear during turning
- 1/2-inch square cross-section fits standard tool holders
- Four-inch overall length provides reach for deep cuts
- Right- and left-hand orientation suits both feed directions
- Non-bevelled profile delivers a clean starting edge
Specifications
| Brand | Cleveland |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
Will the 1/2 in square blank fit the tool post on my older lathe?
The blank measures 1/2 in wide by 1/2 in high by 4 in long, so it matches standard tool posts that accept that shank size.
How can I verify the M2 high-speed steel is performing correctly after grinding?
A properly hardened M2 blank holds a keen edge in mild steel without rapid dulling and shows no chipping during interrupted cuts.
Does the package include a pre-ground cutter or only the blank?
Only the non-beveled high-speed steel blank is supplied; grinding to the required profile is done by the user.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
