Cleveland
Cleveland C94569 Countersink 1/2 in 82° 1-3/4 in
Cobalt countersink cuts 82-degree chamfers in 1/2-inch holes with a bright uncoated finish
- TypeCountersinks & Sets
- 82° angle creates clean countersunk holes for flush fasteners
- 1/2 inch diameter suits standard drill chucks and bit holders
- Cobalt construction resists heat and wear in tough materials
- Bright uncoated finish reduces friction and prevents galling
- 1-3/4 inch overall length provides reach in deep workpieces
Cleveland C94569 Countersink 1/2 in 82°
This Cleveland C94569 countersink creates 82-degree chamfers in drilled holes. The 1/2-inch body fits standard drill chucks for use with hand drills or drill presses. Cobalt construction resists heat and wear when cutting steel and other hard metals. The bright uncoated finish suits general-purpose workshop tasks.
Cobalt material and 82-degree angle capacity
Cobalt steel holds a sharp edge longer than high-speed steel in abrasive materials. The fixed 82-degree angle matches common flat-head fastener standards for flush seating. The tool handles through-holes and deep countersinking up to its flute length. It runs out when a different angle or larger diameter is required.
Upgrade from high-speed steel countersinks
This replaces standard HSS countersinks when tool life in stainless steel or hardened alloys is too short. The jump is worth it for repetitive production work where frequent resharpening slows output. It does not suit users who need adjustable angles, replaceable pilots or coated flutes for non-ferrous metals.
Highlights
- 82° angle creates clean countersunk holes for flush fasteners
- 1/2 inch diameter suits standard drill chucks and bit holders
- Cobalt construction resists heat and wear in tough materials
- Bright uncoated finish reduces friction and prevents galling
- 1-3/4 inch overall length provides reach in deep workpieces
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Countersinks & Sets |
Questions about this item
Will the 1/2 in shank on this C94569 countersink fit the chuck on my older drill press?
The 1/2 in shank matches standard drill press chucks, so it fits most older machines that accept that size.
How can I confirm the 82° angle is cutting correctly after I install it?
Check that the screw head sits flush with the workpiece surface; a clean, flush fit shows the 82° angle is working as intended.
Does the box include any pilot drills or only the cobalt countersink itself?
Only the single cobalt countersink is supplied; pilot drills or drill bits must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
