Cleveland
Cleveland C91695 pneumatic accessory counterbore 3.000" L .219" dia
A high-speed steel counterbore with built-in pilot, 3.000" long and .219" diameter for #6 wire applications
- High-speed steel construction resists wear during repeated drilling
- Built-in pilot ensures accurate hole alignment without separate guide
- 000" overall length reaches deep counterbore applications
- .219" diameter matches #6 wire gauge fastener clearance
- Bright finish reduces corrosion and improves chip visibility
Cleveland C91695 counterbore overview
The Cleveland C91695 is a high-speed steel counterbore with a built-in pilot measuring .219 inch in diameter and 3.000 inch in overall length. It is designed for precision hole preparation in metalworking applications where a flat-bottom recess is required for fastener heads.
Suited for machinists and fabricators
This tool suits machinists and fabricators who need a standard #6 wire-size counterbore for creating accurate seatings in ferrous and non-ferrous materials. It is not intended for buyers who require interchangeable pilots, larger diameters, or carbide-tipped cutting edges for high-volume production runs.
Capacity and headroom
The .219 inch pilot diameter and 3.000 inch length provide adequate reach and alignment for typical counterboring tasks in general workshop environments. High-speed steel construction offers good wear resistance for moderate use, though the tool will dull faster than carbide alternatives when used continuously in abrasive or hardened materials.
Highlights
- High-speed steel construction resists wear during repeated drilling
- Built-in pilot ensures accurate hole alignment without separate guide
- 000" overall length reaches deep counterbore applications
- .219" diameter matches #6 wire gauge fastener clearance
- Bright finish reduces corrosion and improves chip visibility
Specifications
| Brand | CLEVELAND |
|---|
Questions about this item
What size drill chuck is needed to hold the 0.219" diameter shank?
A drill chuck that can clamp a 0.219 inch shank is required; standard 1/4 inch or 3/8 inch capacity chucks will accept this size.
Can this counterbore be used in a standard handheld drill motor?
Yes, it fits any rotary tool with a chuck large enough for the 0.219 inch shank, including common corded or cordless drill motors.
How do I confirm the counterbore is cutting correctly after installation?
The built-in pilot should guide the cutter to produce a clean, flat-bottomed hole at the correct depth for a #6 wire gauge fastener.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
