Cleveland
Cleveland C86147 Spiral Point Tap M14x2 110mm Cobalt TiAlN 3 Flute
M14×2 metric spiral-point tap in cobalt with TiAlN coating, 110 mm overall length, three flutes, right-hand thread
- M14x2 metric thread fits standard 12.00 mm tap drill
- 110 mm overall length reaches deep holes in one pass
- Cobalt substrate with TiAlN coating resists heat and wear
- Spiral-point design pushes chips ahead for smooth through-hole tapping
- Three flutes balance strength and chip clearance for reliable cuts
Cleveland Spiral Point Tap M14x2 Cobalt TiAlN
The Cleveland C86147 is a metric spiral point tap designed for through-hole threading in metal. Its 3-flute cobalt construction with TiAlN coating suits machinists and maintenance technicians who need reliable chip evacuation and extended tool life.
110 mm overall length with 45.01 mm thread length
The 110 mm overall length provides reach for deeper holes while the 45.01 mm thread length supports standard engagement. Right-hand cutting action and plug chamfer promote steady cutting forces and manageable heat buildup during continuous use.
12.00 mm drill size for 75 percent thread depth
A 12.00 mm drill produces the correct 75 percent thread height for the M14x2 6H class of fit. Builders needing a different thread percentage, left-hand threads, or a bottoming chamfer must select an alternative tap.
Highlights
- M14x2 metric thread fits standard 12.00 mm tap drill
- 110 mm overall length reaches deep holes in one pass
- Cobalt substrate with TiAlN coating resists heat and wear
- Spiral-point design pushes chips ahead for smooth through-hole tapping
- Three flutes balance strength and chip clearance for reliable cuts
Specifications
| Brand | CLEVELAND |
|---|
Questions about this item
How do I install the Cleveland C86147 M14x2 spiral point tap correctly, and what step is often missed?
Drill the hole to the specified 12.00 mm diameter for 75 percent thread engagement, then run the 110 mm cobalt TiAlN tap with its 45.01 mm thread length using proper cutting fluid and steady alignment; the step most often missed is verifying the drill size before tapping.
What maintenance or replacement will the Cleveland C86147 M14x2 tap need after extended use?
The cobalt substrate with TiAlN coating resists wear, but the three-flute cutting edges will eventually dull; plan to resharpen or replace the tap when thread quality drops below the 6H class-of-fit tolerance.
What limit appears first when the Cleveland C86147 M14x2 tap is used continuously in hard material?
Heat buildup at the 45.01 mm thread length is the first limiting factor; the TiAlN coating extends life, yet sustained high-speed cutting without adequate coolant will degrade edge integrity faster than flank wear alone.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
