We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C80418 carbide end mill, TiAlN coated, 47 deg helix, .125 in diameter, .5 in cut length

Cleveland

Cleveland C80418 Carbide End Mill TiAlN 47 deg .125 .5 pneumatic accessory

SKU CH-9FSP-1XPWD

Carbide end mill with TiAlN coating, 47-degree helix, 0.125-inch diameter and 0.5-inch cut length for milling

  • TypeMilling
  • TiAlN coating extends tool life during high-speed milling
  • 47 degree helix improves chip evacuation in deep cuts
  • 125 inch diameter suits precision profiling work
  • 5 inch length of cut reaches shallow pockets
  • Carbide substrate resists wear in abrasive materials

Carbide End Mill for Precision Milling

This Cleveland carbide end mill uses a TiAlN coating to resist wear during high-speed milling. The 47-degree helix angle promotes efficient chip evacuation in a variety of materials. It features a 0.125-inch milling diameter and a 0.5-inch length of cut for detailed work. The straight shank measures 1/8 inch for secure tool holding.

Suited for Detailed Finishing Operations

Machinists performing light profiling or slotting in steel, stainless steel or titanium will benefit from the coating and geometry. The non-coolant-through design limits use in deep-pocket applications requiring through-tool coolant delivery. Shops needing extended reach should note the neck diameter is not applicable on this model. Heavy roughing passes are outside the intended scope of this tool.

Integrates with Standard 1/8-Inch Holders

The 1/8-inch shank fits directly into ER collets, end mill holders or shrink-fit chucks of matching size. Overall length of 1 1/2 inches keeps the tool compact inside tight machine envelopes. Carbide construction allows higher spindle speeds than high-speed steel alternatives. No special coolant plumbing is required for operation.

Highlights

  • TiAlN coating extends tool life during high-speed milling
  • 47 degree helix improves chip evacuation in deep cuts
  • 125 inch diameter suits precision profiling work
  • 5 inch length of cut reaches shallow pockets
  • Carbide substrate resists wear in abrasive materials

Specifications

BrandCLEVELAND
TypeMilling

Questions about this item

What size collet or chuck do I need for the 1/8 in shank on this C80418 end mill?

Use a 1/8 in collet or chuck that matches your milling machine’s spindle taper for the .125 in shank diameter.

Will the 47 deg helix and 0.5 in length of cut work with a standard manual knee mill?

The 47 deg helix and .5 in length of cut are compatible with manual knee mills when proper speeds and feeds for carbide tooling are observed.

How can I confirm the TiAlN coating is performing correctly during the first cuts?

A consistent gold-violet surface on the flutes and reduced built-up edge after the initial passes indicate the TiAlN coating is functioning as intended.

More in Power & Pneumatic Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.