Cleveland
Cleveland C75096 4-Flute HSS Square End Mill 8mm
An 8 mm high-speed steel square end mill with four flutes, a 19.05 mm cutting length and a 9.52 mm Weldon shank
- TypeMilling
- 4-flute design improves chip evacuation and surface finish
- High-speed steel construction resists wear during general milling
- 8 mm cutting diameter suits a range of slot and profile work
- 05 mm length of cut allows deeper passes in one operation
- Weldon flat shank provides secure clamping in standard holders
Cleveland C75096 End Mill
The Cleveland C75096 is a four-flute high-speed steel square end mill designed for general milling tasks. It suits machinists and maintenance technicians who need a centre-cutting tool for slotting and profiling operations.
Weldon Flat Shank
The 9.52 mm shank features a Weldon flat that locks securely into a matching end-mill holder, preventing pull-out during heavy cuts. No coating is applied, so the uncoated surface is suitable for materials where coatings offer no advantage or where re-sharpening is preferred.
Straightforward Holder Mounting
Installation consists of inserting the flatted shank into a Weldon-compatible holder and tightening the set screw against the flat. The 63.5 mm overall length fits standard tool changers, but the 19.05 mm length of cut limits depth in a single pass, so deeper features require multiple steps.
Highlights
- 4-flute design improves chip evacuation and surface finish
- High-speed steel construction resists wear during general milling
- 8 mm cutting diameter suits a range of slot and profile work
- 05 mm length of cut allows deeper passes in one operation
- Weldon flat shank provides secure clamping in standard holders
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Milling |
Questions about this item
When should the 8 mm high-speed-steel flutes be resharpened or replaced?
Resharpen when flank wear becomes visible or cutting forces rise sharply; the uncoated HSS can be reground multiple times before the 19.05 mm length of cut is exhausted.
What limits continuous cutting with the 9.52 mm Weldon shank?
Heat buildup in the uncoated high-speed steel is the first limit; without coolant-through capability the tool softens faster than a coated or carbide equivalent under sustained load.
How much noise and heat does the 63.5 mm overall-length cutter generate in all-day operation?
Expect typical high-speed-steel milling noise and noticeable heat at the cutting zone; the uncoated 8 mm diameter runs hotter than coated tools, so plan for external coolant or air blast.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
