We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Cleveland C75095 square end mill, high speed steel, uncoated, Weldon flat shank

Cleveland

Cleveland C75095 Square End Mill 7 mm 19.05 mm 9.52 mm 63.5 mm

SKU CH-77Q9-QDF30

A high-speed steel square end mill with a 7 mm cutting diameter and 19.05 mm length of cut for general milling tasks

  • TypeMilling
  • 7 mm milling diameter suits fine-detail work
  • 05 mm length of cut enables deeper passes
  • 5 mm overall length fits standard tool holders
  • 52 mm shank with Weldon flat prevents slippage
  • High-speed steel construction resists wear in general milling

Application fit

The Cleveland C75095 is a square end mill made from high-speed steel with an uncoated finish and a Weldon flat shank. It suits general milling tasks in workshop and light production environments where a standard tool is required.

Capacity and headroom

A 7 mm milling diameter and 19.05 mm length of cut provide room for typical slotting and profiling passes. The 63.5 mm overall length and 9.52 mm shank diameter limit reach in deep cavities or when extra rigidity is needed.

Thermals noise and power

High-speed steel construction handles moderate cutting temperatures without coating degradation. Uncoated flutes run warmer in abrasive materials, so feed rates may need adjustment to manage heat buildup.

Highlights

  • 7 mm milling diameter suits fine-detail work
  • 05 mm length of cut enables deeper passes
  • 5 mm overall length fits standard tool holders
  • 52 mm shank with Weldon flat prevents slippage
  • High-speed steel construction resists wear in general milling

Specifications

BrandCLEVELAND
TypeMilling

Questions about this item

Will the 9.52 mm Weldon flat shank fit my older mill's 3/8" collet?

The shank is 9.52 mm, which equals 3/8 inch, so it matches a standard 3/8" Weldon holder. The flat must engage the set screw for proper grip.

How do I confirm the 7 mm cutter is running true after installation?

Check run-out at the 19.05 mm flute length with a dial indicator; it should read near zero. Then take a light test cut and measure the slot width for size and finish.

Does the C75095 come with any holder, coolant tube or coating?

The box contains only the uncoated high-speed steel end mill. No holder, coolant hardware or coating is included; purchase a compatible Weldon holder separately.

More in Power & Pneumatic Accessories

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.