Cleveland
Cleveland C64109 Pipe Tap 1/4"-18 Semi-Bottoming 5 Flutes NPTF
A 1/4"-18 NPTF semi-bottoming pipe tap with five flutes for threading pipe and conduit
- TypeTaps
- NPTF taper threads seal pipes without sealant
- Semi-bottoming design starts threads in blind holes
- Five flutes clear chips for smoother cutting
- High-speed steel resists wear in steel and iron
- 1/4"-18 size matches standard pipe fittings
Cleveland C64109 Pipe Tap
The Cleveland C64109 is a high-speed steel pipe tap designed to cut internal NPTF threads in pipe and conduit fittings. It features a 1/4"-18 thread size with five flutes and a semi-bottoming chamfer for threading close to the bottom of a hole. The bright, uncoated finish suits general-purpose tapping in ferrous and non-ferrous materials. Right-hand cutting direction matches standard thread requirements.
Who this suits, who it does not
This tap suits maintenance technicians and pipefitters creating pressure-tight NPTF connections in 1/4 inch pipe. The semi-bottoming design helps when thread depth is limited by a shoulder or blind hole. It is not for through-hole tapping where a taper or plug chamfer clears chips more efficiently. Buyers cutting larger diameters, different thread standards, or left-hand threads need a different tool.
1/4"-18 NPTF thread size
The defining specification is the 1/4"-18 NPTF thread size, which determines compatibility with the pipe fitting being threaded. The 75 percent thread drill size of .4375 in guides the required tap drill selection for proper thread engagement. Using an incorrect drill size or thread standard will produce a non-sealing joint. Verify the workpiece material and hole depth match the tap’s high-speed steel construction and 1 1/16 in thread length.
Highlights
- NPTF taper threads seal pipes without sealant
- Semi-bottoming design starts threads in blind holes
- Five flutes clear chips for smoother cutting
- High-speed steel resists wear in steel and iron
- 1/4"-18 size matches standard pipe fittings
Specifications
| Brand | CLEVELAND |
|---|---|
| Type | Taps |
Questions about this item
How can I confirm the tap is cutting the correct 1/4"-18 NPTF threads after setup?
The tap produces 1/4"-18 NPTF threads with a 75 percent thread depth when used with a .4375 in drill size; verify thread engagement and gauge fit on the workpiece.
What comes with the Cleveland C64109 pipe tap and what must I supply?
The box contains the high-speed steel tap with 5 flutes, semi-bottoming design, 2 7/16 in overall length and 1 1/16 in thread length; you must provide a .4375 in drill bit and a suitable tap wrench.
When should I choose this 1/4"-18 NPTF 5-flute semi-bottoming tap over other versions?
Choose this tap when you need a 1/4"-18 NPTF thread in a blind or through hole, require the chip clearance of 5 flutes in high-speed steel, and can use a .4375 in drill for 75 percent thread depth.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
